JVC DR-MH200SE manual Recording, HDD Deck Only

			TIMER RECORDING EN 49
	Automatic Satellite Programme
			● Make sure the satellite receiver is connected to the unit’s
			[L-2 IN/DECODER] connector.
	Recording		● Programme the timer on the satellite receiver.
			● Slide the TV/CABLE/SAT/DVD switch to DVD.
	(HDD Deck Only)
			1 Press HDD to choose the recording deck.
			2 Set AL-2 SELECTB to ASAT VIDEOB or ASAT S-VIDEOB.
This function allows you to automatically record a satellite
			(A pg. 65)
programme which is timer programmed on your external satellite			● Also refer to AIMPORTANTB on page 68.
receiver. Connect a satellite receiver to the unit’s [L-2 IN/			3 Press REC MODE repeatedly to set the recording mode.
DECODER] connector and programme the timer on the satellite
			4 Press and hold SATj for about 2 seconds to engage the
receiver. The unit starts or stops recording by the signals input
from the satellite receiver. After recording, the unit’s power shuts			Automatic Satellite Programme Recording mode. ASATjB
off automatically.			appears on the front display panel.
			NOTES:
ATTENTION:
			● To disengage the Automatic Satellite Programme Recording
● Be sure not to turn on the satellite receiver before the			mode, press SATj.
		programme is executed; otherwise, the unit will start recording	● If the unit’s power is off, it is not possible to engage the Automatic
		when the satellite receiver’s power is turned on.	Satellite Programme Recording mode.
● If you have connected another appliance other than a satellite			● In step 4, if ASATjB blinks quickly on the front display panel even
		receiver to the [L-2 IN/DECODER] connector, be sure not to	though your satellite receiver’s power is off, Automatic Satellite
		engage the Automatic Satellite Programme Recording mode;	Programme Recording will not work properly with that satellite
		otherwise, the unit will start recording when the connected	receiver*. If this is the case, perform AManual Timer
		appliance’s power is turned on.	ProgrammingB (A pg. 47) to timer record a satellite programme.
● Automatic Satellite Programme Recording and timer recording			* Some satellite receivers output signals even if the power is off. Automatic
		cannot be done at the same time.	Satellite Programme Recording is not possible with those satellite
			receivers.

HDD

CABLE/SAT

TVDVD

HDD

●ASATjB blinks on the front display panel while Automatic Satellite Programme Recording is in progress.

●For timer programming of the satellite receiver, refer to the instruction manual of the satellite receiver.

●Automatic Satellite Programme Recording is not possible if your satellite receiver does not have a timer.

●If there are more than one satellite programmes you wish to record with Automatic Satellite Programme Recording, it is not possible to set different recording modes for each programme.

●Depending on the type of satellite receiver, the unit may not record a slight portion of the beginning of the programme or may record slightly longer than the actual length of the programme.

●If you engage the Automatic Satellite Programme Recording mode when the satellite receiver’s power is on, the unit will not

start Automatic Satellite Programme Recording even though ASATjB blinks on the front display panel. When the satellite receiver shuts off once and is turned back on again, the unit starts recording.

●You can also record a programme from your cable system in the same way if the system has a timer.

●Just Clock (A pg. 77) does not work when the Automatic Satellite Programme Recording mode is engaged.

REC MODE

SAT#