JVC DR-MH200SE manual Installing Satellite Controller

22 EN SAT CONTROL SET

The following procedure is required if you receive satellite

Satellite Receiver Control Setting channels through a satellite receiver. Approximately 20 seconds before the SHOWVIEW timer programming (A pg. 45) or Manual

Satellite receiver

Timer programming (A pg. 47) starts, the unit sets its input mode to AL-2Band automatically switches the satellite receiver’s channels using the provided Satellite Controller.

Your unit	Satellite Controller
	(supplied)
	(suggested location)
	Transmitter
Satellite receiver

Satellite Controller (supplied)

21-pin SCART cable (supplied)

Installing Satellite Controller

1Place the Satellite Controller so that the path between its transmitter and the satellite receiver’s remote sensor is unobstructed.

2Fix securely using the adhesive strip attached on the back of the Satellite Controller.

3Be sure to connect the unit’s [L-2 IN/DECODER] connector to the satellite receiver’s 21-pin SCART connector.

NOTE:

When connecting your satellite receiver, refer to its instruction manual.

4Connect the Satellite Controller to the [SAT CONTROL] connector on the rear panel.

Setting Satellite Receiver’s Brand And Channel

After installation, set the satellite receiver’s brand and channel correctly; otherwise, the Satellite Controller cannot work correctly.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

1Turn on the satellite receiver’s power.

2Press SET UP to access the Main Menu screen.

3Press selection keys to select AINITIAL SET UPB, then press

G.

To [SAT CONTROL]

To [L-2 IN/

DECODER]

Back of unit

4Press selection keys to select ATUNER SETB, then press G.

5Press selection keys to select ASAT CONTROL SETB, then press ENTER.

6Press selection keys to select ABRANDB, then press ENTER.

DVD VIDEO SET UP HDD/DVD SET UP			FUNCTION SET UP	INITIAL SET UP
TUNER SET		CLOCK SET
	AUTO CH SET		MANUAL CH SET
	SAT CONTROL SET		GUIDE PROG SET
SET UP	ENTER	SELECT WITH @ THEN PRESS [ENTER]
		PRESS [SET UP] TO EXIT
EXIT	SELECT

CABLE/SAT

TV DVD

7Press selection keys to select the brand code from the list on page 23, then press ENTER.

●If the unit is in playback or recording mode, you cannot set the brand code.

8Press selection keys to select APROGRAMMEB, then press

ENTER.

9Press selection keys to select one of the channel positions on the satellite receiver, then press ENTER.

●You can select the channel position between 1 to 999.

ENTER

Selection Keys

FGDE

10 Press selection keys to select ATESTB, then press ENTER. The unit enters the Test mode.

INITIAL SET UP > SAT CONTROL SET

BRAND		73
PROGRAMME		12
		TEST
SET UP	ENTER	SELECT WITH @ THEN PRESS [ENTER]
		PRESS [SET UP] TO EXIT
EXIT	SELECT

SET UP