SCOPE SETTING*1
Configure the settings for the wave form monitor and vector scope.
Item | Content |
| Setting value | |
| GAIN | Adjust the input gain level. | |||
| SIZE *2 | Set the window size. | NORMAL, LARGE | ||
| POSITION *2 | Select the window position. | 1 (Lower right), 2 (Lower left) | ||
|
|
|
| 3 (Upper left), 4 (Upper right) |
| TRANSPARENT | Activates/deactivates the function to make the window translucent. | ON | ||
| ON | : | Translucent | OFF |
|
| |||
| OFF | : | Normal |
|
|
|
| ||
| AUTO OFF | Set the function to turn off the window automatically 15 minutes after displayed. | ON, OFF | ||
| WAVE DISPLAY | Select a wave form to be displayed for the wave form monitor. | Y, Pb, Pr (HD signal) | ||
|
|
|
| Y, Cb, Cr (SD signal) |
|
|
|
| R, G, B (RGB signal) |
| WAVE FILTER | Turn on/off the lowpass filter to put over the input wave form data. | FLAT (No filter) | ||
|
|
|
| LOWPASS |
|
|
| ||
| WAVE OVER LEVEL | Set the over levels of the luminance signals (Y) and RGB signals. |
| ||
| Example of the wave form monitor | Example of the vector scope | ||
| Ex.: When the luminance signal is Y, “MARKING” is set to “ON” and “LEVEL” is set to | Ex.: When the color bar is | ||
| “080” |
| displayed | |
RedWhite
Y
Image signals
Start | End |
•The wave form color of signals over the value specified in “LEVEL” turns red.
•The display differs depending on the input signal or the “WAVE DISPLAY” setting.
| – MARKING | Turn on/off the function to change the wave form color of signals over the value | OFF, ON |
| specified in “LEVEL.” (☞ below) |
|
| – LEVEL | Adjust the lower limit for the over level. | 070 – 109 |
*1 | The wave form monitor is not displayed when the input signals are DVI (input from a computer). The vector scope is not displayed when the input |
| signals are RGB. |
*2 | When “SIZE” is set to “LARGE,” the window is displayed in the center of the screen regardless of the “POSITION” setting. |
SYNC FUNCTION
Settings for the synchronization with signals.
Item | Content |
|
| Setting value |
| NO SYNC ACTION | Select the screen status when no signal is coming in. | OFF | ||
| P.SAVE | : | Power save mode | P.SAVE |
| GRAY B. | |||
| GRAY B. | : | Gray screen | |
|
| |||
|
|
| ||
| DELAY TIME | Select the period until the screen status changes as selected in “NO SYNC ACTION” after | 30sec., 5min., 15min. | ||
| signals stop coming in. |
| ||
| LOW LATENCY | Activates/deactivates the function to shorten the time taken to display the picture. | ON | ||
| • If the picture is not displayed steadily while “ON” is selected, select “OFF.” | OFF | ||
•While “ON” is selected, the displayed picture may become unstable when an operation using buttons on the front panel or the menu is performed, or when the signal format changes.
●When setting “NO SYNC ACTION” to “GRAY B.,” the screen color changes to gray and the power consumption of the back light is saved by half. Selecting “P.SAVE” (power save mode) saves more power consumption by turning off the back light.
●In the initial setting, “NO SYNC ACTION” is set to “P.SAVE”, and “DELAY TIME” set to “15min.” Change the settings if necessary. (U.S.A. only)
17