Installation

●Do not rest your arm on the monitor or lean against the monitor.

●Do not touch the LCD panel when installing the monitor.

●Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury.

●How to set up 1

You can tilt the monitor as follows.

When the monitor is not tilted (0°), the guidelines align as illustrated below.

Guidelines

Monitor

Approx. 12°

0° Stand

Approx. 8°

●Be careful not to pinch your fingers in the gap between the monitor and the stand.

●When the stand plate is attached to the lower position of the stand body, you cannot tilt the monitor downward.

●How to set up 2

When the stand plate is attached to the higher position of the stand body, you can place the monitor as illustrated below.

1Remove the screws on the sides of the stand (see the following illustration), and lift up the stand by approximately 144 degrees.

 

Approx.

Screw (silver)

144°

2 Attach the removed screws and place the monitor as illustrated below.

●To place the monitor as shown in “How to set up 1” again, remove the screws on the sides of the stand, align the guidelines, and then reattach the screws.

Cautions

●When lifting up the stand...

-Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.

-Be careful not to pinch your fingers in the moving parts.

●Make sure of lifting the stand up until it stops (Approx. 144°); otherwise the monitor may fall over.

●Place the monitor on a mat to avoid scratching the table surface.

●Do not lift up the stand when the stand plate is attached to the lower position of the stand body.

●To detach the stand

Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.

Attachment screws

Screw holes for stand

Stand body

 

attachment

 

Monitor

●To install the stand

When attaching the stand to the monitor, insert the guides of the stand plate into the guide holes on the monitor to place the stand in the correct position. Then fix the stand firmly with the attachment screws.

Guide holes

Guides

Monitor

Screw holes for stand attachment

Stand plate

Stand body

●To adjust the stand height

To change the stand height, detach the stand from the monitor. Then, change the position of the stand plate according to the stand height you want by choosing the screw holes to use.

<Higher position>

<Lower position>

Screw holes

Screw holes

for higher position

for lower position

Stand

Stand

plate

plate

 

6