Setting the menu (cont.)

REMOTE SETTING (☞ “External Control” on pages 22)

Settings for the external control.

Item

Content

Setting value

SERIAL TYPE

Select the input terminal used for external control by serial

RS232C

 

communication.

RS485

PARALLEL TYPE

Select the external control method for the MAKE/TRIGGER terminal.

MAKE, TRIGGER, SET

PIN1

Assign the control functions to the pins of the MAKE/TRIGGER terminal.

☞ <Functions controlled by the

PIN2

• Assign a function to each pin terminal by selecting “SET” in “PARALLEL

MAKE/TRIGGER system> on page

PIN3

TYPE” mentioned above.

23.

PIN4

 

 

PIN5

 

 

PIN6

The functions are assigned for “PIN6” – “PIN8” and you cannot change the

☞ “Using the MAKE/TRIGGER

PIN7

assignment of these functions.

system” on page 22

PIN8

 

 

CONTROL LOCK Setting value: OFF, VOL.LOCK, ALL LOCK

Settings for disabling the buttons on the front panel.

●The following operations are not available when “VOL.LOCK” is selected.

–VOLUME adjustment knob

–Picture adjustment knob

●The “ALL LOCK” function disables to control the buttons on the front panel. But following operations are available.

–Turning on/off (on standby) the monitor.

–Press thebutton andbutton to display the SET-UP MENU, and set “CONTROL LOCK” to “OFF.”

–Operate this product by external control.

When you perform operations other than the above, “Control lock on!” appears.

DVI INPUT SEL. Setting value: AUTO, COMPO., RGB, PC

Settings for formats of signals input into the DVI-D (HDCP) terminal.

●Automatically distinguishes signals when set to “AUTO.” (Normally, select “AUTO”)

●Select “COMPO.”, “RGB” or “PC” when the picture is not displayed correctly with “AUTO.”

●DVI-D input of the monitor is compatible with HDCP.

SDI FORMAT Setting value: AUTO, MS1YCbCr, MS2YCbCr, MS3YCbCr, MS4YCbCr, MS2 RGB, MS3 RGB, 3G-B-I

When “AUTO” is selected, 3G SDI/HD-SDI DUAL LINK signals are automatically recognized. (Normally select “AUTO.”)

●If the picture is unstable with “AUTO”, select the setting value according to the input signal format.

●“M” is displayed on the status display when a setting other than “AUTO” is selected.

20