JVC GET0467-001A Indications Setting, reference Initial, Speakers through an external amplifier

Indications	Item			Setting, [reference page]
	(		: Initial)
L/O MODE	• REAR			: Select if both the LINE OUT terminals are used for connecting the
Line output mode				speakers (through an external amplifier).
	• WOOFER			: Select if the REAR LINE OUT terminals are used for connecting a
				subwoofer (through an external amplifier).
WOOFER*3	• LOW			: Frequencies lower than 90 Hz are sent to the subwoofer.
Subwoofer cutoff	•	MID		: Frequencies lower than 135 Hz are sent to the subwoofer.
frequency	• HIGH			: Frequencies lower than 180 Hz are sent to the subwoofer.
AUX ADJ	A.ADJ 00			: Adjust the auxiliary input level to avoid the sudden increase of the
Auxiliary input level	— A.ADJ 05			output level when changing the source from external component
adjustment				connected to the AUX input jack on the control panel.
TAG DISP	• TAG ON			: Shows the Tag information while playing MP3/WMA tracks, [10].
Tag display	• TAG OFF			: Cancels.
AMP GAIN	• LOW PWR			: VOL 00 – VOL 30. (Select this if the maximum power of the speaker is
Amplifier gain				less than 50 W to prevent damaging the speaker.)
control	•	HIGH PWR		: VOL 00 – VOL 50.
AREA	•	AREA US		: When using in North/Central/South America. AM/FM intervals are set
Tuner channel				to 10 kHz/200 kHz.
interval	•	AREA EU		: When using in any other areas except North/Central/South America.
				AM/FM intervals are set to 9 kHz/50 kHz (100 kHz during auto search).

•AREA SA : When using in South American countries. AM/FM intervals are set to 10 kHz/100 kHz.

IF BAND	•	AUTO	:	Increases the tuner selectivity to reduce interference noises between
Intermediate				close stations. (Stereo effect may be lost.)
frequency band	•	WIDE	:	Subject to interference noises from adjacent stations, but sound
				quality will not be degraded and the stereo effect will remain.

*3 Displayed only when “L/O MODE” is set to “WOOFER.”

ENGLISH

15