1
KD-PDR35
Installation/Connection Manual
GET0468-010A
[UT]
L
Handles
H
Washer (ø5)
ø5
I
Lock nut (M5)
M5
J
Mounting bolt (M5 × 20 mm)
M5 × 20 mm
A / B
Hard case/Control panel
C
Sleeve
D
Trim plate
E
Power cord
ENGLISH
This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does
not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.
Parts list for installation and connection
The following parts are provided for this unit. If any item is missing, consult your JVC car audio dealer
immediately.
M
Remote controller
N
Battery
1206DTSMDTJEIN
EN, CT
PRECAUTIONS on power supply and speaker connections:
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit
will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in
your car.
© 2006 Victor Company of Japan, Limited
Heat sink
WARNINGS
To prevent short circuits, we recommend that you disconnect the battery’s negative terminal and make all
electrical connections before installing the unit.
• Be sure to ground this unit to the car’s chassis again after installation.
Notes:
• Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio
dealer.
• It is recommended to connect to the speakers with maximum power of more than 50 W (both at
the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than
50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 15 of the
INSTRUCTIONS).
• To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
F
Connection cable for iPod
iPod
12 V
JVC
•
•
JVC
• 50 W 4 Ω - 8 Ω 50 W
AMP GAIN
15
•
•
•
•
JVC
K
Rubber cushion
G
Cable tie
Install1_KD-PDR35_1.indd 1Install1_KD-PDR35_1.indd 1 2006.12.6 3:08:36 PM2006.12.6 3:08:36 PM