JVC GR-DVL820, GR-DVL1020 specifications 24 EN, To cancel Blank Search midway, Press

Load a tape (☞ pg. 12).

24 EN TAPE PLAYBACK (cont.)

BLANK Button

Power Switch

Lock Button

Display

44

BLANK SEARCH

VIDEO/MEMORY Switch (GR-DVL1020/ DVL820/DVL520 only; open the LCD monitor to access this switch.)

Stop Button (5)

Blank Search

Helps you find where you should start recording in the middle of a tape to avoid time code interruption (☞ pg. 20).

1

2 Set the VIDEO/MEMORY Switch to “VIDEO” (GR-DVL1020/DVL820/DVL520 only), then set the Power Switch to “PLAY” while pressing down the Lock Button located on the switch.

3 Press BLANK.

•“BLANK SEARCH” appears blinking and the camcorder automatically starts reverse or forward shuttle search, then stops at the spot which is about 3 seconds of tape before the beginning of the detected blank portion.

To cancel Blank Search midway . . .

..... press 5.

NOTES:

●In step 3, if the current position is at a blank portion the camcorder searches in the reverse direction, and if the current position is at a recorded portion the camcorder searches in the forward direction.

●Blank Search does not work if “HEAD CLEANING REQUIRED. USE CLEANING CASSETTE” has appeared with the tape.

●If the beginning or end of the tape is reached during Blank Search, the camcorder stops automatically.

●A blank portion which is shorter than 5 seconds of tape may not be detected.

●The detected blank portion may be located between recorded scenes. Before you start recording, make sure there is no recorded scene after the blank portion.