64 EN | USING THE REMOTE CONTROL UNIT (cont.) |
Power Switch |
Lock Button
Display
6w
12 : 3 4
Remote sensor
START/STOP
INSERT
REW 
PLAY
STOP 
PAUSE
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.
NOTES:
●Before performing the following steps, make sure that
“TIME CODE” is set to “ON” in the Menu Screen (☞ pg. 49, 51).
●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
●To perform Insert Editing while watching in the television, make connections (☞ pg. 22).
1 Play back the tape, locate the
2 Press REW (2) until the
3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). “6w” and the Time Code (min.:sec.) appear and the camcorder enters
4 Press START/STOP to begin editing.
•Confirm the insert at the time code you checked in step 1.
•To pause editing, press START/STOP. Press it again to resume editing.
5 To end Insert Editing, press START/STOP, then STOP (5).
NOTES:
●Programme AE with special effects (☞ pg. 38, 39) can be used to spice up the scenes being edited during Insert Editing.
●During Insert Editing, the date and time information changes.
●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert Edting stops (☞ pg. 86).
