![](/images/new-backgrounds/1140856/14085699x1.webp)
50 EN
VIDEO/DSC Switch
Power Switch
Lock Button
F |
| LP |
A | ||
FO Y |
|
SNAPSHOT
Button
MENU Wheel
Display
CAMERA Menu
SNAP MODE – P I
FRAME
FUL L
MUL T I – 4
MUL T I – 9
NOTES:
●To remove the shutter sound, “BEEP” on pg. 38, 40.
●Even if
● If Snapshot recording is not possible, “ ” blinks when SNAPSHOT is pressed.
●If Program AE with special effects ( pg. 46) is engaged, certain modes of Program AE with special effects are disabled during Snapshot recording. In such a case, the icon blinks.
●If SNAPSHOT is pressed when “DIS” is set to “ON” ( pg. 39), the Stabiliser will be disabled.
●During playback as well, all snapshot modes
are available when “ COPY” is set to “OFF” in the Menu Screen ( pg. 42). However, the shutter sound is not heard.
●When a cable is connected to the AV connector, the shutter sound is not heard from the speaker, however it is recorded onto the tape.
FOR RECORDING (cont.)
Snapshot (For Video Recording)
This feature lets you record still images that look like photographs onto a tape.
SNAPSHOT MODE SELECTION
1 Set the VIDEO/DSC Switch to “VIDEO” (GR- DVM75 only), then set the Power Switch to “ ” while pressing down the Lock Button located on the switch. Open the LCD monitor fully or pull out the viewfinder fully.
2 Press the MENU Wheel in. The Menu Screen appears.
3 Rotate the MENU Wheel to select “ CAMERA”. Press it and The CAMERA Menu appears.
4 Rotate the MENU Wheel to select “SNAP MODE”, then press it.
5 Rotate the MENU Wheel to select the desired Snapshot mode, then press it. Rotate the MENU Wheel to select “RETURN” and press it twice. The Menu Screen closes.
•The available Snapshot modes are as the same as those on page 27.
SNAPSHOT RECORDING
1 Press SNAPSHOT. appears while the snapshot is being taken.
If you press during Record-Standby . . .
.... “PHOTO” appears and a still image will be
recorded for approx. 6 seconds, then the camcorder
If you press during Recording . . .
.... “PHOTO” appears and a still image will be
recorded for approx. 6 seconds, then the normal recording resumes.
•Regardless of the Power Switch position (“ ” or “
”), Snapshot recording takes place using the selected Snapshot mode.
•To use the flash
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar to serial photography. (Interval between still images: approx. 1 second)
●The Motor Drive mode is disabled when “REC SELECT”
is set to “ /
” in the Menu Screen ( pg. 41).