![](/images/new-backgrounds/1140856/140856135x1.webp)
68 EN
USING THE REMOTE CONTROL UNIT (cont.)
Insert Editing
Display
12 : 34
Remote sensor
REW
STOP
6w
START/STOP
INSERT
PLAY
PAUSE
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.
NOTES:
●Before performing the following steps, make sure that “TIME CODE” is set to “ON” in the Menu Screen ( pg. 41, 43).
●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
●To perform Insert Editing while watching in the television, make connections ( pg. 22).
1 Play back the tape, locate the
2
3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). “6w” and the Time Code (min.:sec.) appear and the camcorder enters Insert- Pause mode.
4 Press START/STOP to begin editing.
•Confirm the insert at the time code you checked in step 1.
•To pause editing, press START/STOP. Press it again to resume editing.
5 To end Insert Editing, press START/STOP, then STOP (5).
NOTES:
●Program AE with special effects ( pg. 46, 47) can be used to spice up the scenes being edited during Insert Editing.
●During Insert Editing, the date and time information changes.
●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops ( pg. 91).