![](/images/new-backgrounds/1140856/140856153x1.webp)
DETAILS | EN77 | |
I T E M S | N O T E S |
|
|
|
|
➪ Power | ❍ Perform charging where the temperature is between 10°C and | |
( pg. 8) | 35°C (50°F and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal | |
| temperature range for charging. If the environment is too cold, | |
| charging may be incomplete. |
❍Charging times are for a fully discharged battery pack.
❍Charging time varies according to the ambient temperature and the status of the battery pack.
❍To avoid interference with reception, do not use the AC Adapter near a radio.
❍Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in
❍The following operation stops charging:
| •Set the Power Switch to “ | ”, “ ” or “ ”. |
| •Disconnect the AC adapter from the camcorder. | |
| •Unplug the AC adapter’s power cord from the AC outlet. | |
| •Detach the battery from the camcorder. | |
|
| |
➪ VIDEO | ❍ When you use the LCD monitor outdoors in direct sunlight, the | |
RECORDING | LCD monitor may be difficult to see. If this happens, use the | |
( pg. 18, 19) | viewfinder instead. |
|
❍The cassette holder cannot be opened unless a power supply is attached.
❍There may be a delay after you open the cassette holder cover until the cassette holder opens. Do not use force.
❍Once the cassette holder is closed, it recedes automatically. Wait until it recedes completely before closing the cassette holder cover.
❍When the Recording Start/Stop button is pressed, it may take a
few seconds before actual recording starts. “” starts rotating when the camcorder actually starts recording.
❍The time required to calculate and display the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.
❍“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for
5 minutes. “TAPE END” also appears when a cassette at its end is loaded.
❍During recording, sound is not heard from the speaker. To hear the sound, connect optional headphones to the AV IN/OUT (headphone) connector. The sound volume is at the level it was adjusted to during playback ( pg. 21).