48 EN
Fade/Wipe Effects
These effects let you make
IMPORTANT:
Some Fade/Wipe Effects cannot be used with certain modes of Program AE with special effects ( pg. 46, 47). If an unusable Fade/ Wipe Effect is selected, its indicator blinks or goes out.
VIDEO/DSC Switch
Lock Button
F |
| LP |
A | ||
FO Y |
|
Recording
Start/Stop
Button
Power Switch
MENU Wheel
FOR RECORDING (cont.)
FADE/WIPE SELECTION ( | , | , | , | , | ||||
, | , | , | , | and | ) |
|
|
|
Fade or Wipe works when video recording is started or when you stop recording.
1 Set the VIDEO/DSC Switch to “VIDEO” (GR- DVM75 only), then set the Power Switch to “ ” while pressing down the Lock Button located on the switch. Open the LCD monitor fully or pull out the viewfinder fully.
2 Press the MENU Wheel in. The Menu Screen appears.
3 Rotate the MENU Wheel to select “ WIPE/ FADER”, then press it.
4 Rotate the MENU Wheel to select the desired function, then press it. Selection is complete. Press the MENU Wheel in again.
•The WIPE/FADER Menu disappears and the effect is reserved. The indicator representing the selected effect appears.
5 Press the Recording Start/Stop Button to activate the
NOTES:
●You can extend the length of a Fade or Wipe by pressing and holding the Recording Start/ Stop Button.
●If the power is turned off after a scene is finished recording, the stored point is erased, disabling the Picture Wipe/Dissolve combination. When this happens, the Picture Wipe/Dissolve indicator blinks. Also note that power shuts off automatically if 5 minutes elapse in the
●The sound at the end of the last recorded scene is not stored.
●Picture Wipe/Dissolve cannot be used while