EN 11
Using The Battery Pack
A
Notches
B
BATT. RELEASE
Switch
1Align the battery pack’s two notches with the tabs on the camcorder’s battery pack mount.
2Insert the terminal end 1 of the battery pack into the battery pack mount.
3Firmly push the end 2 of the battery pack until it locks into place.
To detach the battery pack...
While sliding down BATT. RELEASE, remove it.
NOTE:
When using the battery pack and the S/AV/Editing cable, disconnect the S/AV/Editing cable first ( pg. 25), and then detach the battery pack.
Approximate recording time
Battery pack | LCD monitor on | Viewfinder on | |
|
|
| |
1 hr. | 1 hr. 10 min. | ||
|
|
| |
2 hr. | 2 hr. 20 min. | ||
(optional) | |||
|
| ||
|
|
| |
5 hr. 10 min. | 6 hr. | ||
(optional) | |||
|
| ||
|
|
| |
7 hr. 40 min. | 9 hr. 10 min. | ||
(optional) | |||
|
| ||
|
|
|
NOTES:
●Recording time is reduced significantly under the following conditions:
•Zoom or
•The LCD monitor is used repeatedly.
•The playback mode is engaged repeatedly.
●Before extended use, it is recommended that you prepare enough battery packs to cover 3 times the planned shooting time.
ATTENTION:
Before detaching the power source, make sure that the camcorder’s power is turned off. Failure to do so can result in a camcorder malfunction.
INFORMATION:
The optional
Read the kit’s instruction manual before using. Also, by using the optional JVC
Using AC Power
To AC outlet | Power cord |
AC Power Adapter/
Charger
POWER indicator
(red)
To DC OUT 
connector
DC cord
To battery pack mount
1Make sure you unplug the camcorder’s DC cord from the AC Power Adapter/Charger.
2Plug the AC Power Adapter/Charger’s power cord into an AC outlet. The POWER indicator lights.
3Attach the coupler part of the DC cord to the camcorder’s battery pack mount.
4Plug the DC cord to the DC OUT connector on the AC Power Adapter/Charger.
NOTES:
●The provided AC Power Adapter/Charger features automatic voltage selection in the AC range from 110 V to 240 V.
●For other notes, pg. 81.
