EN 23
Master Page: Right
GR-DVP7-5EG_18-25.fm Page 23
Blank Search
Helps you find where you should start recording in
the middle of a tape to avoid time code interruption.
(墌pg.21)
1Load a cassette. (墌pg.16)
2Set the VIDEO/MEMORY Switch to “VIDEO”.
3Set the Power Switch to “P” while pressing
down the Lock Button located on the switch.
4During Stop mode,
press FOCUS/BLANK.
●The “BLANK
SEARCH”
indication appears
blinking and the
camcorder
automatically starts
reverse or forward search, then stops at the
spot which is about 3seconds of tape before
the beginning of the detected blank portion.
5To cancel Blank Search midway, press 8.
NOTES:
●Before starting Blank Search, if the current position
is at a blank portion, the camcorder searches in
the reverse direction. If the current position is at a
recorded portion, the camcorder searches in the
forward direction.
●Blank Search does not work if “HEAD CLEANING
REQUIRED. USE CLEANING CASSETTE” has
appeared with the tape.
●If the beginning or end of the tape is reached
during Blank Search, the camcorder stops
automatically.
●A blank portion which is shorter than 5 seconds of
tape may not be detected.
●The detected blank portion may be located
between recorded scenes. Before you start
recording, make sure there is no recorded scene
after the blank portion.
Slow-Motion PlaybackFrame-By-Frame PlaybackPlayback ZoomPlayback Special Effects
Available only with the remote control (provided).
(墌pg.68, 69)
FOCUS/BLANK Switch
Power Switc h
Stop Button (8)
Lock Button
VIDEO/MEMORY Switch
BLANK SEARCH
5
GR-DVP7-5EG_02-08.book Page 23 Thursday, February 28, 2002 11:39 AM