![](/images/new-backgrounds/1157254/157254143x1.webp)
72 EN | USING THE REMOTE CONTROL UNIT (cont.) |
![](/images/new-backgrounds/1157254/157254143xi2.webp)
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.
Remote sensor
4Press START/STOP to begin editing.
●Confirm the insert at the time code you checked in step 1.
●To pause editing, press START/STOP. Press it again to resume editing.
5To end Insert Editing, press START/STOP, then STOP (8).
NOTES:
●Program AE with special effects ( pg. 38, 41) can be used to spice up the scenes being edited during Insert Editing.
●During Insert Editing, the date and time information changes.
●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops. ( pg. 100, 101)
START/STOP
INSERT
REW PLAY
STOP
NOTES:
PAUSE
● Before performing the following steps, make sure that “TIME CODE” is set to “ON”. ( pg. 38, 48)
● Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
● To perform Insert Editing while watching in the television, make connections. ( pg. 24, 25)
1 Play back the tape, locate the
2 Press REW (3) until the
3 Press and hold INSERT
(I) on the remote
9I
control, then press PAUSE (9). The “9I” indicator and the Time Code (min.:sec.)
appear and the 12 : 34 camcorder enters