EN 53
Master Page: Right
GR-DVP7-5EG_37-79.fm Page 53
Once the camcorder is set, the camcorder operator
can become part of the scene in a more natural way,
adding the final touch to a memorable picture.
1Set the Power Switch to “M” while pressing down
the Lock Button located on the switch.
2Open the LCD monitor fully, or pull out the
viewfinder fully.
3Set “SELF TIMER” to
“ON ”. (墌pg.38)
●You can tilt the LCD
monitor upward to
180° so that it faces
forward and view
yourself while self-
recording with the
viewfinder pushed
back.
4To engage the Self-
Timer for video
recording, press the
Recording Start/Stop
Button.
●After 15seconds, the
beep sounds and
video recording
starts.
5To stop Self-Timer recording, press the Recording
Start/Stop Button again.
●The camcorder re-enters Record-Standby
mode.
OR
5Press SNAPSHOT.
●After 15seconds, the beep sounds and
snapshot recording starts. After that, the
camcorder re-enters Record-Standby mode.
6To end Self-Timer recording, select “OFF” in
step3.
NOTE:
If “BEEP” and “TALLY”are set to “OFF” (墌pg.47),
the beep does not sound and the tally lamp does not
light.
Self-Timer
Power Swit ch
Lock Button
VIDEO/MEMORY Switch
Recording Start/
Stop Button
MENU Button
SET/SELECT Button +,– Button
SELF–T IMER –
ON
OFF
Self-Timer indication
When the Recording Start/Stop Button or SNAPSHOT
is pressed, the tally lamp changes as shown:
Begins blinking
(Self-Timer starts)
Blinks quickly
(Self-Timer shooting
starts soon)
Turns off
(Self-Timer snapshot recording starts)
Stops blinking and stays on
(Self-Timer video recording starts)
After approx. 15sec.
GR-DVP7-5EG_02-08.book Page 53 Thursday, February 28, 2002 11:39 AM