86 EN
Master Page: Left
GR-DVP7-5EG_80-103.fm Page 86
34. Coloured bright spots appear
all over the LCD monitor or the
viewfinder.
34. •The LCD monitor and the
viewfinder are made with
high-precision technology.
However, black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD
monitor or the viewfinder.
These spots are not recorded
on the tape. This is not due to
any defect of the unit.
(Effective dots:more than
99.99 %)
34.
—
35. The indicators and the image
colour on the LCD monitor are
not clear.
35. •This may occur when the
surface or the edge of the
LCD monitor is pressed.
35.
—
36. The cassette will not load
properly.
36. •The cassette is in the wrong
position.
•The battery’s charge is low.
36. •Set it in the right position.
(墌pg.16)
•Install a fully charged battery.
(墌pg.10, 11)
37. The memory card will not load
properly.
37. •The memory card is in the
wrong position.
37. •Set it in the right position.
(墌pg.17)
38. The memory card cannot be
removed from the camcorder.
38. —38. •Push in the memory card a
few more times. (墌pg.17)
39. Picture does not appear on the
LCD monitor.
39. •The viewfinder is pulled out.
•The LCD monitor’s brightness
setting is too dark.
39. •Push the viewfinder back in.
•Adjust the brightness of the
LCD monitor. (墌pg.13)
•If the monitor is tilted
upward 180 degrees, open
the monitor fully. (墌pg.13)
40. Images on the LCD monitor
are jittery.
40. •The speaker volume is too
great.
40. •Turn the speaker volume
down. (墌pg.22)
41. The LCD monitor, the
viewfinder and the lens have
become dirty (ex. fingerprints).
41.
—
41. •Wipe them gently with soft
cloth. Wiping strongly can
cause damage. (墌pg.91)
42. Time code does not appear. 42. •“TIME CODE” is set to
“OFF”.
42. •Set “TIME CODE” to “ON”.
(墌pg.38, 48, 51)
43. An unusual mark appears. 43.
—
43. •Check the section of the
manual that explains LCD
monitor/viewfinder
indications. (墌pg.96 – 99)
TROUBLESHOOTING (cont.)GR-DVP7-5EG_02-08.book Page 86 Thursday, February 28, 2002 11:39 AM