EN 75
Select Scenes
● To change previously registered points, press |
CANCEL on the remote control. The registered |
points disappear, one at a time, from the most |
recently registered point. |
● If you are not using Wipe/Fader or Program AE |
Remote sensor
FADE/WIPE
EFFECT
EDIT IN/OUT
PLAY
R.A.EDIT
ON/OFF
with special effects, repeat steps 8 and 9 only. |
NOTES:
● When choosing a scene, set |
points so that there is a relatively large difference |
between them. |
● If the search time for an |
5 minutes, the recording deck’s |
mode will be cancelled and editing will not take |
place. |
● If there are blank portions before or after the Edit- |
In and |
CANCEL
6Point the remote control at the camcorder’s remote sensor. Press PLAY (U) and then press R.A.EDIT ON/OFF on the remote control.
The Random Assemble Editing Menu appears.
7 If using a Wipe/Fader at the beginning of the scene, press FADE/WIPE on the remote control. ● Cycle through the
effects by pressing repeatedly, and stop
when the one you want is displayed.
●You cannot use a Picture Wipe/Dissolve at the beginning of Program 1.
8At the beginning of the scene, press EDIT IN/ OUT on the remote control. The
9At the end of the scene, press EDIT IN/OUT. The
10If using a Wipe/Fader at the end of the scene, press FADE/WIPE.
●Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.
●If you select a Wipe/Fader effect for an
●You cannot use a Picture Wipe/Dissolve at the end of the last scene.
●When you use Fader/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve.)
11If using Playback Special Effects, press EFFECT. ( pg. 69)
12Repeat steps 8 through 11 to register additional scenes.
included in the edited version. |
● Since time codes register time only as accurately |
as seconds, the time code total time may not |
match the total program time exactly. |
● Turning off the camcorder’s power erases all |
registered |
● If you select Sepia or Monotone mode from |
Program AE with special effects, you cannot use |
the Dissolve or Black & White Fader. In this case |
the Dissolve or Black & White indicator begins |
blinking. Once the next |
the effect is turned off. To combine these effects, |
use Sepia or Monotone during recording, then use |
the Dissolve or Black & White Fader during |
Random Assemble Editing. |
● It is not possible to use Wipe/Fader effects and |
Program AE with special effects during Random |
Assemble Editing using a DV cable. |
Fader And Wipe Menu
(available only for Random Assemble Editing)
You can also use the fader/wipe effects on page 40.
DISSOLVE: The new scene gradually appears as the old one gradually disappears.
WIPE – CORNER: The new scene wipes in over the previous one from the upper right corner to the lower left corner.
WIPE – WINDOW: The next scene gradually wipes in from the center of the screen toward the corners, covering the previous scene.
WIPE – SLIDE: The next scene gradually wipes in over the previous one from right to left.
WIPE – DOOR: The previous scene wipes out from the center to the right and left, like a door being pushed open to reveal the next scene.
WIPE – SCROLL: The new scene wipes in over the last one from the bottom of the screen to the top.
