16 EN GETTING STARTED |
|
|
| |
Data Battery System | Operation Mode | |||
You can check the remaining battery power and | ||||
To turn on the camera, set the power switch to | ||||
the recordable time. | ||||
1 Make sure the battery is attached. | or | while pressing down the lock button | ||
located on the switch. | ||||
2 Open the LCD monitor fully. | ||||
● The power/charge lamp turns on. | ||||
3 Press INFO/ repeatedly, and the battery | To turn off the camera, set the power switch to | |||
status screen appears. | OFF. |
|
| |
|
|
| ||
● It is displayed for approx. 3 seconds if the | 1 Power Switch |
| ||
button is pressed and released quickly, and for |
| |||
|
|
| ||
approx. 15 seconds if the button is pressed |
|
| Power/Charge Lamp | |
and held for several seconds. |
|
|
| |
● If “COMMUNICATING ERROR” appears |
|
|
| |
instead of the battery status even though you |
|
|
| |
tried to press INFO/ several times, there |
|
|
| |
may be a problem with your battery. In such a |
|
|
| |
case, consult your nearest JVC dealer. |
| 2 MODE |
| |
● The recordable time display should only be |
| Lock Button | ||
used as a guide. It is displayed in 10 minute | 4 LCD Monitor | |||
units. | 3 | |||
Using AC Power
Perform step 4 in “Charging the Battery Pack” ( pg. 14).
NOTE:
Set the appropriate operation mode according to your preference using the power and MODE switches and 
(
/
) button.
The provided AC adapter features automatic voltage 1 Power Switch Position selection in the AC range from 110 V to 240 V.
About Batteries
DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion. WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.
To resume the original function of the accurate battery power indication
If the battery power indication differs from the actual operating time, fully charge the battery, and then run it down. However this function may not work properly if the battery was used for a long period of time under extremely high/low temperature condition or charged too many times.
Set the power switch for recording (
) or playback (
) while pressing down the lock button.
Power Switch
Power Off
Playback
Recording
