JVC HR-S5800AM Video Channel Set, Access Video Channel SET Mode, EN I Nitial Sett Ings

6ENINITIALSETTINGS

Video Channel Set

Video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the video recorder through the RF cable.

STOP/EJECT

PR +/–

OK

If you have connected the video recorder to your TV via the provided RF cable only (RF connection) – Go to "With RF Connection" below.

If you have connected the video recorder to your TV via both the provided RF cable and an AV cable (AV connection), or via the provided RF cable, the provided S-Video cable and an audio cable (S-VIDEO connec- tion) – Go to "With AV Connection or S-VIDEO Connection" on next page.

With RF Connection

IMPORTANT:

Before performing the following steps, make sure the recorder's power is off and there is no cassette inserted in the recorder.

ACCESS VIDEO CHANNEL SET MODE

	Hold down STOP/EJECT on the recorder until the
1	display panel shows the following.
	SELECT TV SYSTEM
	Press PR +/– to set appropriate TV system that matches
2 the system of TV being used (refer to the table below).
	1 : B/G 2 : D/K 3 : I 4 : H	5 : M*
	Major Countries	TV System
	New Zealand, Kuwait, U.A.E.,
	Indonesia, Singapore, Thailand,		B/G
	Malaysia, Iran, Saudi Arabia,
	Egypt, Morocco, Lebanon, Iraq
	China, Mongolia, Russia		D/K
	Hong Kong		I
	Australia		H
	U.S.A., Japan, S.Korea, Taiwan		M*
	*HR-S5800AM only

TEST SIGNAL

The channel on which the screen to the left appear clearly in step 3 is your Video Channel.

To view picture signals from the video recorder, set your TV to the Video Channel.