42 EN
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.

SET REMOTE CONTROL

CODE FOR REMOTE

CONTROL

1
1Press and hold VCR.
2Press the NUMBER key “2”.
3Press OK, and release VCR.
●The remote control now can transmit B code control
signals.

CHECK REMOTE CONTROL

CODE FOR RECORDER

2
Press and hold PLAY on the recorder for more than
5␣seconds while the recorder is turned off. The code
currently set appears on the display panel.

CHANGE CODE FOR

RECORDER

3
Press any key on the remote control. The recorder now
responds to B code control signals.
To control two recorders with the
same remote control
You can control two JVC recorders by switching the remote
control code for the remote control between A and B (Z step
1), keeping two recorders to different control codes.
●To change only the remote control code for the remote
control, DO NOT perform steps 2 and 3.
NOTE:
To set the recorder back to respond to A code signals, repeat thesame procedure as shown above except pressing NUMBER key"1" instead of "2" in step
2
of 1.

SPECIAL FEATURES

RemoteControlFunctions
NUMBER "2"
VCR
NUMBER "1"
OK
PLAY