EN 7
(Ex.) If channel 50 is available in your area
SET VIDEO CHANNEL
3
Set your TV to UHF channel 36.
●If the two vertical white bars appear clearly on the
screen as shown in the illustration (Z "TEST SIGNAL"
on page 6), press OK and then go to step 4.
●If the two vertical white bars do not appear clearly,
press OK and then PR +/– to set the video recorder
to a vacant channel between 28 and 60 which is not
occupied by any local station in your area.
Then set your TV to UHF channel 50 and check if the
two vertical white bars appear clearly on the screen; if
so, go to step 4. If not, re-set the video recorder to
another vacant channel and try again.
NOTES:
●
If you set the video recorder to a channel which isoccupied by a local station or has neighbouringchannels that are occupied by local stations, thepicture reception quality will be affected and someinterference noise will appear on the TV screen. Besure to select a vacant channel which has nobroadcast on neighbouring channels.
●
If you cannot obtain the two vertical white barsclearly with any channel between 28 and 60, consultyour JVC dealer.FINISH VIDEO CHANNEL
SET
4
Press OK.
●If Auto Set Up (Z pg. 8) or Tuner Set (Z pg. 54)
has not previously been performed, the Language
Select screen appears and Auto Set Up function
takes place automatically.

With AV Connection or

S-VIDEO Connection

IMPORTANT:

Before performing the following steps, make sure the
recorder's power is off and there is no cassette inserted in
the recorder.
ACCESS VIDEO CHANNEL
SET MODE
1
Hold down STOP/EJECT on the recorder until the
display panel shows the following.
SET VIDEO CHANNEL
2
Press OK, then press PR – until the display panel shows
the following.
FINISH VIDEO CHANNEL
SET
3
Press OK.
●If Auto Set Up (Z pg. 8) or Tuner Set (Z pg. 54)
has not previously been performed, the Language
Select screen appears and Auto Set Up function
takes place automatically.
To view picture signals from the video recorder, set
your TV to its AV mode.
A
(MONO)
Installing/Removing the lithium battery
1Make sure that the power plug is connected to an AC outlet
and turn off the recorder power.
2Open the battery cover while pressing the release tab as
illustrated.
3Insert a lithium battery with the plus (+) side up and push it in.
●To remove the lithium battery, press the latch A down-
ward using a pointed non-metallic object, then pull out
the lithium battery.
4Close the battery cover until it clicks in place.
Be sure to connect the power plug to an AC outlet first
before installing the lithium battery; otherwise, the
battery's service life will be drastically shortened.
Now the video channel is set to off (– –).