JVC HR-S9400EH specifications Ming Screen, Enter Showview, EN Timer Recording

28ENTIMERRECORDING

SHOWVIEW		During SHOWVIEW and regular timer programming, the Illumi-
		Guide feature tells you which button on the remote control
		must be pressed next by lighting it up. To use this feature, with
Timer		the TV/SAT/VCR switch set to "VCR", press ILLUMI GUIDE
		before performing step 1. (PROG, REW, PLAY, FF light up at this
	time.)
	If you aren't going to use the Illumi-Guide feature, go directly to
Recording	step 1.
			ACCESS TIMER PROGRAM-
			MING SCREEN
Before performing SHOWVIEW timer recording:	1
● Be sure to read "SHOWVIEW Setup" (☞ pg. 12).			Press PROG.
● Insert a cassette with the safety tab in place. The recorder			TIMER PROGRAMMING
will come on automatically.

●Turn on the TV and select the VIDEO channel (or AV mode).

●Set the PAL/MESECAM switch to the appropriate position. ☞ pg. 16

											[0 – 9] : SHOWVIEW
* For Customers in Australia and New Zealand:											[+/–] : EXPRESS PROGRAMMING
											[MENU] : MAIN MENU
With this recorder, the G-Code system is identified as "SHOWVIEW".
										The front display panel looks like this:
									8
••	• •	•• ••	• •	••						● If you are using the Illumi-Guide feature, the following
•	• • •	• •	• • •	•	PAL/MESECAM					CANCEL.
										buttons will light up: NUMBER keys (0–9), START +/–,
										STOP +/–,DATE +/–,TV PROG +/–,MENU and
TIMER						2				ENTER SHOWVIEW
					1	2	3
NUMBER					AILY	5	6			NUMBER
					4
							ADD TIME
					7	8	9		WEEKLY	Press the NUMBER keys to	SHOWVIEW
	:PDC/VPS									enter the SHOWVIEW
											1 2 3 4 5 6 7 8
									TIMER	2 number of a programme
	CANCEL					0	4
										you wish to record.
										● If you make a mistake,
										press CANCEL to	[0 – 9] =
								TV/SAT/VCR		backspace and then
		SP/LP								input the correct number.	[CANCEL] : DELETE
											[MENU] : EXIT
									CHECK	The SHOWVIEW number
										you enter appears on the front display panel:
							PROG
					1	3		OK		The display panel can only show 4 digits at a time.
PROG/MENU
										● If you are using the Illumi-Guide feature, OK blinks
										when the following buttons are lit: NUMBER keys (0–
										9), CANCEL and MENU.
							ILLUMI GUIDE

When Using The Illumi-Guide Feature

●Buttons light or blink on the remote control for approximately 10 seconds. If the button or buttons extinguish during timer programming, press ILLUMI GUIDE and the button or buttons previously lit or blinking come back on. If the button or buttons do not re-light or start blinking again, press MENU and re-perform the timer programming procedure from the beginning.

●If for some reason the remote control's signal is not received by the video recorder, press MENU and re-perform the timer programming procedure from the beginning.