JVC HR-S9500EH Access Manual, Channel SET Screen, Select NEW Station, Switch Stations

54ENSUBSIDIARYSETTINGS(cont.)

Set Stations (A)

Set station names that are registered in your recorder.

Perform steps 1 and 2 of "Storing Channels Manually" on page 52 to access the Confirmation screen before continuing.

1	SELECT ITEM
	Press %Þ%%until the item you want begins blinking.
	ACCESS MANUAL
2	CHANNEL SET SCREEN
	Press OK twice.
3	SELECT NEW STATION
	Press%until the station
	name (ID) begins blinking,
	then press %Þuntil the	PR CH ID FINE DECODER
	new station’s name (ID)	06 CH45 – –Ê – – +/– OFF
	you want to store begins
	blinking.
	Registered station names	[5°] : CHANGE ID
	(☞ pg. 55) appear as you	[°°] : CURSOR +=
		: OK
	press %Þ.	[MENU] : EXIT
4	SWITCH STATIONS
	Press OK.
	● The Confirmation screen appears.
	● Repeat steps 1 through 4 as necessary.
	CLOSE CONFIRMATION
5	SCREEN
	Press MENU.

Set Stations (B)

Set station names other than the ones registered in your recorder.

Perform steps 1 and 2 of "Storing Channels Manually" on page 52 to access the Confirmation screen and then perform steps 1 and 2 of "Set Stations (A)" on the left before continuing.

SELECT STATION NAME

CHARACTER

1	Press		%until the first letter
		of the station name begins
		blinking.			PR CH ID	FINE DECODER
					06 CH45 ARD	+/– OFF
					[5°] : A-Z, 0-9
					[°°] : CURSOR +=
					: OK
					[MENU] : EXIT
		ENTER NEW CHARACTER
	Press %Þ to cycle through the characters (A–Z, 0–9, –,
	*, +,		(space) ) and stop when the desired character
2 is indicated,[				then press%to enter. Enter the remaining
		characters the same way (maximum of 4).
		After entering all characters, press OK.
		● The Confirmation screen appears.
		● If you make a mistake, press%until the incorrect
		character begins blinking. Then enter the correct
		character by pressing %Þ.
		CLOSE CONFIRMATION
		SCREEN
3 Press MENU.