46 EN
JLIP
AV1 IN/OUT
AV2 IN/DECODER
AV1 OUT
COMP. Y/C
RL
AUDIO
PAUSE/
R.A. EDIT
ANT. IN
RF OUT
OUT
S OUT
DECODER VCR TV
EXT.2 EXT.1
Connection To A SatelliteTuner
The AV2 IN/DECODER connector on the rear panel of your recorder allows simple connection to a satellite tuner.
Mains outlet
TV Aerial
cable
Aerial connector
Satellite Tuner Unit
Satellite Cable
Outdoor Unit Aerial
Back of TV
21-pin AV input
connector (SCART)
RF OUT
ANT. IN
Back of Recorder

SYSTEM CONNECTIONS

NOTE:

Refer to the instructions supplied with your satellite tuner.

IMPORTANT
Set "AV2 SELECT" to "SAT" on the Mode Set screen (Z pg. 39).
If you set "AV2 SELECT" to "SAT"...
● It is possible to view a satellite programme with the TV set to its AV mode even if the recorder's power is turned off.
● The AV2 IN/DECODER connector's input is the same signal that is controlled by the rear panel AV1 OUT switch as shown below:
a- If both the satellite tuner and the TV are compatible with the Y/C signal, set the AV1 OUT switch to Y/C in order to take
advantage of high-quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the
Y/C signal.)
b- If the satellite tuner and/or the TV are/is not compatible with the Y/C signal, set the AV1 OUT switch to COMP.
AV2 SELECT setting on
the MODE SET screen
SAT
Rear panel AV1 OUT
switch
COMP.
Y/C
AV2 IN/DECODER
connector input signal
Composite signal*
Y/C signal**
* The composite signal is a regular video
signal.
**The Y/C signal is a signal in which the
luminance and chrominance signals are
separated.
AV1 OUT switch