Filename |
|
EN 29
Before performing the following steps:
●Make sure the satellite receiver is connected to the unit’s
●Programme the timer on the satellite receiver.
●Insert a cassette with the safety tab in place.
●Slide the TV/VCR/DVD switch to the right.
A Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
B Select the L-2 SELECT mode.
Set “L-2 SELECT” to “A/V” or “SAT”. ( pg. 64)
●When you select “SAT”, refer to “IMPORTANT” on page 60.
C Set the tape speed.
Press p.
D Engage the Automatic Satellite Programme
Recording mode.
On the unit
Press and hold SAT# for about 2 seconds.
On the remote control Press and hold REC LINK for about 2 seconds.
●The “N” and “#” indicators light up and the unit turns
off automatically.
NOTES:
●Operations on the DVD deck are not possible when the Automatic Satellite Programme Recording mode is engaged or timer recording is in progress.
●To disengage the Automatic Satellite Programme Recording mode, press REC LINK. The “N” indicator goes off.
●If the unit’s power is off, it is not possible to engage the Automatic Satellite Programme Recording mode.
●In step D, if the “N” indicator does not light but instead blinks quickly even though your satellite receiver’s power is off, Automatic Satellite Programme Recording will not work
properly with that satellite receiver*. If this is the case, perform “Express Timer Programming” ( pg. 26) to
*Some satellite receivers output signals even if the power is off. Automatic Satellite Programme Recording is not possible with those satellite receivers.
●The “N” indicator blinks while Automatic Satellite Programme Recording is in progress.
●For timer programming of the satellite receiver, refer to the instruction manual of the satellite receiver.
●Automatic Satellite Programme Recording is not possible if your satellite receiver does not have a timer.
●Pressing the unit’s 1 button while Automatic Satellite Programme Recording is in progress turns off the unit’s power and disengages the Automatic Satellite Programme Recording mode.
●If there are more than one satellite programmes you wish to record with Automatic Satellite Programme Recording, it is not possible to set different tape speeds for each programme.
●Depending on the type of satellite receiver, the unit may not record a slight portion of the beginning of the programme or may record slightly longer than the actual length of the programme.
●If you engage the Automatic Satellite Programme Recording mode when the satellite receiver’s power is on, the unit will not start Automatic Satellite Programme Recording even though the “N” and “#” indicators blink. When the satellite receiver shuts off once and is turned back on again, the unit starts recording.
●You can also record a programme from your cable system in the same way if the system has a timer.
●The B.E.S.T. system ( pg. 23) does not work while Automatic Satellite Programme Recording is in progress.
●Just Clock ( pg. 75) does not work when the Automatic Satellite Programme Recording mode is engaged.
Page 29
September 26, 2003 4:50 pm
