JVC HR-XV32E manual Set Stations a, Set Stations B

Filename [XV3EX_10Subsidiary.fm]
XV3EX_01.book Page 71 Friday, August 22, 2003 12:21 PM	Masterpage:Right-No-Heading

			EN 71
Set Stations (A)
		B Enter the new character.
Set station names that are registered in your unit.
		Press rt to cycle through the characters (A–Z, 0–9, –,
Perform steps A and B of “Manual Channel Set” on page 69		f, +, I (space) ) and stop when the desired character is
to access the Confirmation screen before continuing.		indicated, then press e to enter. Enter the remaining
		characters the same way (maximum of 4). After entering
		all characters, press OK.
A Select the item.
		● The Confirmation screen appears.
Press rt w e until the item you want begins blinking.		● If you make a mistake, press w until the incorrect character
		begins blinking. Then enter the correct character by pressing
B		rt.
	Access the Manual Channel Set screen.
		C Close the Confirmation screen.
Press OK twice.
		Press SET UP MENU.
C
	Select the new station.	NOTE:
Press e until the station		The characters available for the station name (ID) are A–Z, 0–9, –,
		f, +, I (space) (maximum of 4).
name (ID) begins blinking,
then press rt until the new		Fine-Tuning Channels Already Stored
to store begins blinking.
station’s name (ID) you want
Registered station names
( pg. 72) appear as you
		Perform steps A and B of “Manual Channel Set” on page 69
press rt.		to access the Confirmation screen before continuing.

D Switch the stations.

Press OK.

●The Confirmation screen appears.

●Repeat steps A – D as necessary.

E Close the Confirmation screen.

Press SET UP MENU.

Set Stations (B)

Set station names other than the ones registered in your unit.

Perform steps A and B of “Manual Channel Set” on page 69 to access the Confirmation screen and then perform steps A and B of “Set Stations (A)” above before continuing.

A Select the character for station name.

Press e until the first letter of the station name begins blinking.

A Select the channel to fine-tune.

Press rt w e until the channel you want to tune begins blinking.

B Access the Manual Channel Set screen.

Press OK twice. The Manual Channel Set screen appears.

C Perform tuning.

Press e until “+/–” begins blinking, then press rt until the picture is its clearest. Then press OK.

●The Confirmation screen appears.

●Repeat steps A – C as necessary.

D Close the Confirmation screen.

Press SET UP MENU.

Page 71

August 22, 2003 12:20 pm