JVC JY-HD10 manual 12 EN, Grip Adjustment, Tripod Mounting, While using the LCD monitor

12 EN

Grip Adjustment

1Adjust the velcro strip.

2Pass your right hand through the loop and grasp the grip.

3Adjust your thumb and fingers through the grip to easily operate the Recording Start/Stop Button, Power Switch, SNAPSHOT and Power Zoom Switch. Be sure to fasten the velcro strip to your preference.

NOTE:

The grip can rotate 90º downward. It is useful to shoot images below.

Tripod Mounting

To attach the camcorder to a tripod, align the direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise.

●Some tripods are not equipped with studs.

CAUTION:

When attaching the camcorder to a tripod, extend its legs to stabilise the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over.

LCD Monitor And Viewfinder

While using the LCD monitor:

Make sure the viewfinder is pushed back in. Press PUSH OPEN and open the LCD monitor fully. It can rotate 270º (90º downward, 180º upward).

While using the viewfinder:

Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully.

●Be sure to pull out the viewfinder until you hear a click, otherwise it may be pushed back in during use.

180˚

PUSH OPEN Button