JVC JY-HD10 manual Items

DETAILS				EN 67
ITEMS		NOTES
V Power ( pg. 10)	● Perform charging where the temperature is between 10°C and 35°C. 20°C to 25°C
	is the ideal temperature range for charging. If the environment is too cold,
	charging may be incomplete.
	● Charging times are for a fully discharged battery pack.
	● Charging time varies according to the ambient temperature and the status of the
	battery pack.
	● To avoid interference with reception, do not use the AC Power Adapter/Charger
	near a radio.
	● Since the AC Power Adapter/Charger processes electricity internally, it becomes
	warm during use. Be sure to use it only in well-ventilated areas.
V VIDEO	● When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may
RECORDING	be difficult to see. If this happens, use the viewfinder instead.
( pg. 18)	● The cassette holder cannot be opened unless a power supply is attached.
	● There may be a delay after you open the cassette holder cover until the cassette
	holder opens. Do not use force.
	● Once the cassette holder is closed, it recedes automatically. Wait until it recedes
	completely before closing the cassette holder cover.
	● When the Recording Start/Stop button is pressed, it may take a few seconds before
	actual recording starts. The “T” indicator starts rotating when the camcorder
	actually starts recording.
	● The time required to calculate and display the remaining tape length, and the
	accuracy of the calculation, may vary according to the type of tape used.
	● “TAPE END” appears when the tape reaches its end, and the power goes off
	automatically if left in this condition for 5 minutes. “TAPE END” also appears
	when a cassette at its end is loaded.
	● During recording, sound is not heard from the speaker. To hear the sound, connect
	optional headphones to the headphone connector. Adjust the sound volume by
	rotating the MENU Wheel. ( pg. 22)
	● During Interface Shooting, the “Tape Running” indicator and warning indications
	( pg. 73 – 75) are the only ones that are shown; they appear reversed in the
	display as they would when viewing a mirror, but are not reversed in the
	recording.
	● The tape remaining indicator does not appear during interface shooting. However,
	when the remaining time reaches 2 minutes, the indicator appears showing the
	remaining time:	(blinking)	(blinking)	(blinking)

REFERENCES