JVC JY-HD10 Insert Editing DV only, During Insert Editing, set the Recording Mode Switch to DV

EN 59

NOTES:

●When editing onto a tape that was recorded at

12-bit, the old and new soundtracks are recorded separately.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●If you change from 12-bit to 16-bit in mid- recording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit audio or a blank portion, Audio Dubbing stops.

●To perform Audio Dubbing while watching on the television, make connections. ( pg. 24)

●To perform Audio Dubbing with a video unit connected to the camcorder’s S/AV connector, first set “S/AV INPUT” to “A/V IN” or “S IN” in VIDEO Menu. ( pg. 33, 39)

The “AUX” indication appears instead of “MIC”.

Insert Editing (DV only)

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.

A tape that was recorded in HD or SD mode cannot be used for Insert Editing.

START/STOP

INSERT

REW PLAY

indicator and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode.

4Press START/STOP to begin editing.

●Confirm the insert at the time code you checked in step 1.

●To pause editing, press START/STOP. Press it again to resume editing.

5To end Insert Editing, press START/STOP, then STOP (8).

NOTES:

●During Insert Editing, set the Recording Mode Switch to “DV”.

●Special Effects ( pg. 49) can be used to spice up the scenes being edited during Insert Editing.

●During Insert Editing, the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Editing stops. ( pg. 74)

●If a memory card is loaded and “NAVIGATION” is set to other than “MANUAL”, a NAVIGATION thumbnail image is stored in the memory card. ( pg. 50)

ADVANCED FEATURES

STOP

PAUSE

NOTES:

●Before performing the following steps, make sure that “TIME CODE” is set to “ON”. ( pg. 33, 40)

●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Insert Editing while watching in the television, make connections. ( pg. 24)

1Play back the tape, locate the Edit-Out point and press PAUSE (9). Confirm the time code at this point. ( pg. 40)

2Press REW (3) until the Edit-In point is located, then press PAUSE (9).

3Press and hold INSERT (I) on the remote control, then press PAUSE (9). The “9I”