JVC JY-HD10 manual 70 EN, Advanced features, Press Back Light

70 EN			TROUBLESHOOTING (cont.)
Advanced features
	SYMPTOM		POSSIBLE CAUSES		CORRECTIVE ACTION
15.	The focus does not adjust	15.	•Focus is set to the Manual	15.	•Set Focus to the Auto mode.
	automatically.		mode.		( pg. 44)
			•The recording was done in a		•Clean the lens and check the
			dark place, or the contrast		focus again. ( pg. 79)
			was low.
			•The lens is dirty or covered
			with condensation.
16.	In the 5-Second mode,	16.	•The 5-Second mode is set to	16.	•Set “5S” to “5S” in MANUAL
	recording ends before		“Anim.” in MANUAL Menu.		Menu. ( pg. 33, 35)
	5 seconds have elapsed.
17.	Snapshot mode cannot be	17.	•The Squeeze mode (16:9SQ)	17.	•Disengage the Squeeze
	used.		is selected.		(16:9SQ) mode.
					( pg. 33, 36)
18.	The colour of Snapshot looks	18.	•The light source or the	18.	•Find a white subject and
	strange.		subject does not include		compose your shot so that it
			white. Or there are various		also appears in the frame.
			different light sources behind		( pg. 26, 42)
			the subject.		•Disengage the Sepia (SEPIA)
			•The Sepia (SEPIA) or		and Monotone
			Monotone (MONOTONE)		(MONOTONE). ( pg. 33,
			mode is activated.		49)
19.	The image taken using	19.	•Shooting was performed	19.	•Press BACK LIGHT.
	Snapshot is too dark.		under backlit conditions.		( pg. 43)
20.	The image taken using	20.	•The subject is too bright.	20.	•Press P.AE and set
	Snapshot is too bright.				“PROGRAM AE” to
					“SPOTLIGHT”. ( pg. 48)
21.	White Balance cannot be	21.	•The Sepia (SEPIA) or	21.	•Disengage the Sepia (SEPIA)
	activated.		Monotone (MONOTONE)		or Monotone (MONOTONE)
			mode is activated.		mode before setting White
					Balance. ( pg. 49)
22.	Wipe/Fader effects do not	22.	•The Power Switch is set to	22.	•Set the Power Switch to “M”.
	work.		“A”.		( pg. 14)
23.	The Black & White Fader does	23.	•The Sepia (SEPIA) or	23.	•Disengage the Sepia (SEPIA)
	not work.		Monotone (MONOTONE)		and Monotone
			mode is activated.		(MONOTONE).
					( pg. 33, 49)
24.	Program AE does not work.	24.	•The Power Switch is set to	24.	•Set the Power Switch to “M”.
			“A”.		( pg. 14)
25.	Cannot record signals from a	25.	•The connected device is not	25.	•Dubbing from other devices
	device which is connected to		compatible with this		in MPEG2 format is possible
	the i.LINK IN/OUT connector.		camcorder.		if the connected device is
					another same model of this
					unit. It is also possible to dub
					in MPEG2 format from a D-
					VHS VCR, if the source tape
					(D-VHS) has been originally
					dubbed from this digital HD
					video camera in MPEG2
					format.