JVC JY-HD10 manual Indications Meaning, Appears when no tape is loaded  pg

EN 73

Warning Indications

Indications		Meaning
	Displays the battery remaining power.
	Remaining power level: high
	Remaining power level: exhausted
	As the battery power comes close to nil, the battery indicator blinks.
	When the battery power is exhausted, power turns off automatically.
	Appears when no tape is loaded.		( pg. 16)
CHECK TAPE’S ERASE	Appears when the erase protection tab is set to “SAVE” while the Power Switch is
PROTECTION TAB	set to “A” or “M” and the Recording Mode Switch is set to any mode except
	“MEMORY”.		( pg. 14)
HEAD CLEANING	Appears if dirt is detected on the heads during recording. Use an optional
	cleaning cassette.
REQUIRED USE
CLEANING CASSETTE
CONDENSATION	Appears if condensation occurs. When this indication is displayed, wait more
	than 1 hour until condensation disappears.
OPERATION PAUSED
PLEASE WAIT
TAPE!	Appears if a tape is not loaded when the Recording Start/Stop Button or
	SNAPSHOT Button is pressed while the Power Switch is set to “A” or “M” and
	the Recording Mode Switch is set to any mode except “MEMORY”.
TAPE END	Appears when the tape ends during recording or playback.		( pg. 67)
SET DATE/TIME!	● Appears when the date/time is not set.		( pg. 15)
	● Appears when the built-in clock (lithium) battery is discharged and the
	previously set date/time is erased.		( pg. 15)
LENS CAP	Appears for 5 seconds after power is turned on if the lens cap is attached.
CAN NOT PLAY BACK	Appears when you attempt to play back a tape that is not compatible with this
THIS TAPE	camcorder.
CAN NOT CHANGE	Appears when you attempt to change the recording mode during recording.
RECORDING MODE			( pg. 19)
RECORDING IS
STOPPED
INVALID DATA!	Appears when you attempt to record signals which are copygurded or not
CAN NOT RECORD	compatible with this camcorder.
COPY PROTECTED
CAN NOT RECORD

REFERENCES

CONTINUED ON NEXT PAGE