JVC JY-HD10 LCD monitor or Certain Wipe/Fader effects, AE, OIS and other AE and OIS.  pg, Cables

					EN 69
7.	The LCD monitor or	7.	•Certain Wipe/Fader effects,	7.	•Re-read the sections covering
	viewfinder indications blink.		certain modes of Program		Wipe/Fader effects, Program
			AE, “OIS” and other		AE and “OIS”. ( pg. 35, 48)
			functions that cannot be used
			together are selected at the
			same time.
8.	Digital Zoom does not work.	8.	•10X optical zoom is selected.	8.	•Set “ZOOM” to “40X” or
			•The Recording Mode Switch		“200X”. ( pg. 34)
			is set to “MEMORY”.		•Set the Recording Mode
					Switch to an appropriate
					position except “MEMORY”.
Video and D.S.C. Playback
	SYMPTOM		POSSIBLE CAUSES		CORRECTIVE ACTION
9.	Play, Rewind and Fast-Forward	9.	•The Power Switch is set to	9.	•Set the Power Switch to
	functions do not work.		“A” or “M”.		“P”. ( pg. 22)
			•The Playback Mode Switch is		•Set the Playback Mode
			set to “MEMORY”.		Switch to “VIDEO”.
10.	The tape is moving, but there is	10.	•Your TV has AV input	10.	•Set the TV to the mode or
	no picture.		terminals, but is not set to its		channel appropriate for
			VIDEO mode.		video playback. ( pg. 24)
			•The cassette holder cover is		•Close the cassette holder
			open.		cover. ( pg. 16)
11.	Blocks of noise appear during	11.		11.	•Clean the video heads with
	playback, or there is no		—		an optional cleaning
	playback picture and the				cassette.
	screen becomes blue.
12.	A memory card cannot be	12.	•The Power Switch is set to	12.	•Set the Power Switch to
	played back.		“A” or “M”.		“P”. ( pg. 27)
			•The Playback Mode Switch is		•Set the Playback Mode
			set to “VIDEO”.		Switch to “MEMORY”.
13.	The image on the 4:3 TV is	13.	•This occurs during recording	13.	•This is not a malfunction.
	elongated vertically (squeeze).		in HD or SD mode when a		•Disconnect either of two
14.	The screen of the LCD monitor	14.	tape (its erase protection tab	14.	cables.	REFERENCES
			•The S/AV/Editing cable is		•This is not a malfunction.
			is set to “REC”) is loaded.
			•The component video cable
			and S/AV/Editing cable are
			connected simultaneously.
	or viewfinder is blackened or		connected and “S/AV		After dubbing, set “S/AV
	blocks of noise appear on its		INPUT” ( pg. 39) is set to		INPUT” back to “OFF”.
	right side when the Power		“A/V IN” or “S IN”.
	Switch is set to “P” for
	dubbing (but 4·9 is not
	pressed).