Assigning names to the sources
You can assign names to CDs and the external components.
After assigning a name, it will appear on the display when you select the source.
Sources | Maximum number of |
| characters |
|
|
CDs* | up to 32 characters |
| (up to 40 discs) |
External components up to 11 characters
*You cannot assign a name to a CD Text or an MP3 disc.
3 Select the character set you want while
“” is flashing.
Each time you press the button,
the character set changes as
follows:
Capital letters ( 
) 
Small letters ( 
)
Numbers and symbols ( 
) 
4 Select a character.
About the available
characters, see page 53.
ENGLISH
1 Select a source you want to assign a name to.
Each time you press the
button, the source changes
as described on page 8.
5 Move the cursor to the next
(or previous) character position.
2 Press and hold SEL (select) for more than 2 seconds while pressing D (display).
DISC
When you select “CD” as the source
6 Repeat steps 3 to 5 until you finish inputting the name.
7 Finish the procedure while the last selected character is flashing.
To erase the input characters
Insert spaces using the same procedure described above.
Notes:
•When you try to assign a name to the 41st disc, “NAME FULL” appears on the display. (In this case, delete unwanted names before assignment.)
•When the CD changer is connected, you can assign names to discs in the CD changer. These names can also be shown on the display if you insert the discs in this unit.
41
