JVC LPT0649-001B 38 EN, Entire programme while timer-recording in SP mode, For Example

38 EN		SUBSIDIARY SETTINGS (cont.)
		* The default setting is bold in the table below.
8 AUTO SP]LP TIMER	When this function is set to “ON”, the recorder automatically switches to LP
ON	mode to allow complete recording if there is not enough tape to record the
OFF	entire programme while timer-recording in SP mode.
	For Example . . .
	Recording a programme of 210 minutes in length onto a 180-minute tape
	Approximately 150 minutes	Approximately 60 minutes
	SP mode	LP mode
	Total 210	minutes
	Make sure you set this function to “ON”, before the timer-recording starts.
	NOTES:
	● If you have programmed the recorder to timer-record 2 or more programmes, the
	second programme and those thereafter may not fit on the tape if you set “AUTO
	SP]LP TIMER” to “ON”. In this case, make sure the mode is not engaged, then set the
	tape speed manually during timer programming.
	● In order to ensure that the recording fits on the tape, this feature may leave a slight
	non-recorded section at the end of the tape.
	● There may be some noise and sound disturbance at the point on the tape where the
	recorder switches from SP to LP mode.
	● The Auto SP]LP Timer feature is not available during ITR (Instant Timer Recording),
	and the feature will not work properly with any tapes longer than E-180, or with some
	tapes of shorter lengths.
	● If you perform timer recording with both VPS/PDC and the Auto SP]LP Timer
	activated, and the programme goes beyond its originally scheduled length, there may
	be times when the programme cannot be recorded in its entirety.
8 POWER SAVE	When this function is set to “ON”, you can reduce the power consumption
ON	while the recorder is turned off.
OFF	NOTES:
	● During Power Save mode ...
	... the front display panel will be turned off.
	... the Just Clock function ( pg. 46) does not work.
	... the picture may be distorted momentarily when you turn on/off the recorder.
	● Power Save does not work when ...
	... the recorder is in the Timer mode.
	... the recorder’s power is turned off after timer-recording or Instant Timer Recording.
	... “L-2 SELECT” is set to “DECODER” or “SAT” ( pg. 31).
8 VIDEO STABILIZER	When this function is set to “ON”, you can automatically correct vertical
ON	vibration in the picture when playing back unstable recordings made on
OFF	another recorder.
	NOTES:
	● When you finish viewing a tape, be sure to set this function to “OFF”.
	● Regardless of the setting, this function has no effect during recording and during
	special effects playback.
	● The on-screen display may jitter vertically when this function is set to “ON”.
	● To watch recordings with close-caption, set this function to “OFF”.