Filename [HRS5950EU4-EN.fm]
Masterpage:Left
42 EN
Page 42 December 4, 2001 5:11 pm
SUBSIDIARY SETTINGS (cont.)

Manual Channel Set

Store channels that were not stored during Auto Set Up
(墌pg.10) or Auto Channel Set (墌pg. 40).
AAccess the Main Menu screen.
Press MENU.
BAccess the Confirmation screen.

Press rt to move the highlight bar (pointer) to

“MANUAL CH SET”, then press OK or e. The

Confirmation screen appears.

CSelect the channel position.
DSelect the band.
EInput the channel.

Press the number keys to input the channel number you

want to store.

●Input “0” before any single number entries.
●To input the registered station name (ID – 墌pg.45), press e
until “– – – –” (ID setting) begins blinking, then press rt.
●For fine tuning adjustment, press e until “+/–” begins blinking,
then press rt. While tuning, “+” or “–” appears.
●When storing a channel that sends scrambled broadcasts,
press e until “OFF” (Decoder setting) blinks, then press rt
to set “DECODER” to “ON” (“OFF” is the default setting).
●When “L-2 SELECT” is set to “A/V” or “SAT”, the “DECODER”
setting cannot be changed (墌pg.31).
FEnter new channel information.

Press OK and the Confirmation screen appears.

●Repeat steps 3 – 6 as necessary.
GClose the Confirmation screen.
Press MENU.
●To change positions, see “Change Station Channel Position”
(墌pg.43).
●If you wish to set station names other than the ones registered
in your recorder, see “Set Stations (B)” (墌pg.44).

Press rt w e until an open

position in which you want to

store a channel begins

blinking, then press OK. The

Manual Channel Set screen

appears.

(Example) To store in position 12.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.

Press rt to change the band

between CH (regular) and CC

(cable), then press e.

ATTE NTI ON
Guide Program numbers are not set when channels are
stored manually. If an attempt is made at timer programming
with the SHOWVIEW system in this state, the “GUIDE PROG
SET” screen appears; set the Guide Program numbers on this
screen. (墌pg.23, “ATTENTION — Guide Program Number
Set”)
Or perform “Guide Program Number Set” (墌pg.49).
HRS5950EU1-EN.book Page 42 Tuesday, December 4, 2001 5:32 PM