14 EN

SETTING UP

SETTING UP

When you first use your Mobile PC, always plug the AC power cord into the DC Input connector.

The built-in lithium-ion battery pack will be recharged during your PC setup. To avoid data loss due to power failure or any others cause, check the points for battery recharging in Page 16.

1. Unplug the jumper pin before recharging the battery pack

Always unplug the battery terminal jumper pin from the PC rear panel when recharging the battery pack by plugging the AC power cord into the DC Input connector.

Battery terminal jumper pin

Unplug the jumper pin using the tip of a ball point

pen or similar. Jumper pin

The jumper pin is factory-mounted to (disconnect the battery pack from the ) circuitry. The removed pin is not used again.

Tips

Cover the battery terminal with the protection cover of accessory kit if you use the Mobile PC without using the standard lithium ion battery pack or the optional large capacity lithium ion battery pack.

Mounting the Protection Cover

1Slide lock lever A mounted at

the bottom of the Mobile PC in the direction of the arrow.

2 Mount the battery terminal protection cover.

3Slide lock lever A in the direction of the arrow until it locks.

Lock lever A

2. Mounting/Dismounting the Lithium Ion Battery Pack

¡ Mounting Battery Pack

¡ Dismounting Battery Pack

Holes for mounting optional large-capacity lithium ion battery pack

1Slide lock lever A in the direction of the

arrow (outward).

2Mount and lock the battery pack until it

clicks.

3Slide lock lever A in the direction of the

arrow (inward).

4Tighten two coin screws (when the large capacity lithium ion battery pack is used).

1Slide lock lever A in the direction of the arrow.

2 Slide and hold lock lever B in the direction of the arrow, and pull out and dismount the battery pack in direction 3 as shown.

Page 14
Image 14
JVC MP-XP7210GB, MP-XP3210GB warranty 14 EN, Unplug the jumper pin before recharging the battery pack