JVC RX-D701S manual Changing the transmittable signals for operating a VCR

❏Changing the transmittable signals for operating a VCR

1Press and hold VCR .

2Press VCR.

3Enter the manufacturer’s code using buttons 1 – 9, and 0.

See “Manufacturers’ codes for VCR” on the right.

4Release VCR .

Now, you can perform the following operation on the VCR.

VCR :Turn on or off the VCR.

After pressing VCR, you can perform the following operations on the VCR.

CHANNEL +/–:	Change the channel numbers on the
	VCR.
1 – 10, 0, +10:	Select the channel numbers on the VCR.
3:	Start playback.
7:	Stop playback.
8:	Pause playback.
FF:	Fast-wind a tape.
REW:	Rewind a tape.
+ 3:	Start recording.
+ 8:	Enter recording pause. To start
	recording, press this button then 3.

See the instructions supplied with the VCR for details.

5Try to operate your VCR by pressing VCR .

When your VCR turns on or off, you have entered the correct code.

If more than one code is listed for your brand of VCR, try each

one until the correct one is entered.

Manufacturers’ codes for VCR

Manufacturer	Codes
JVC	01, 02, 03, 04
Aiwa	05
Akai	06, 07, 08
Bell+Howell	09
Daewoo	10
Emerson	11, 12, 13, 14, 15
Fisher	16, 17, 18, 19
G.E.	20, 21
Go Video	22
Gold Star	23
Go-Video A	24
Go-Video B	25
Hitachi	20, 26
Magnavox	27, 28, 29
Mitsubishi	30, 31, 32, 33
NEC	34, 35
Panasonic	36, 37
Philips	27
RCA	38
Samsung	39, 40, 41
Sanyo	16, 17, 18, 19
Scott	42
Sharp	43, 44
Shintom	45
Sony	46, 47, 48, 49, 50, 51
Symphonic	52
Teknica	53, 54
Toshiba	55
Zenith	56

Initial setting: 01

Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

51