JVC RX-DP20VBK Setting the Video Input Terminals, Turning On and Off the Video Output, Pcm, Fix

7DIGITAL OUT

Select the output digital signal format through the DIGITAL OUT (optical) terminal on the rear.

•Each time you press the button, the output signal format changes as follows:

THROUGH : Select when connecting a digital signal processor or decoder. The incoming digital signals are transmitted through the digital output terminal without any processing.

PCM	: Select when connecting an MD recorder or other
	digital recording device. The incoming digital
	signals are down-mixed and converted into PCM
	format.

pSetting the Video Input Terminals

—VIDEO INPUT

After connecting the video components to the video input terminals, you have to register which type of the terminal you have connected to—whether the component input or S-Video/ composite input.

Without setting this correctly, you may not view the pictures on the TV.

7VIDEO INPUT

Select an appropriate input terminal used for each component— “DVD,” “DBS,” and “VCR1.”

•Each time you press # (RIGHT) or @ (LEFT), the selected video input terminal changes as follows:

COMPO1 “ COMPO2 “ COMPO3 “ S/C

“(back to the beginning)

Notes:

•If you have selected the same component input terminal for different video components, only the last performed terminal setting will be valid. (The other terminal settings will be automatically set to “S/C.”)

•If any of “COMPO 1/2/3” is selected for the video component which is only connected using S-video or composite video jacks (S/C), you cannot view or record its playback picture.

q Turning On and Off the Video Output

—VIDEO POWER

On this submenu screen, you can turn on or off the power supply to the video output circuit built in this unit.

7VIDEO POWER

Turn on or off the power supply to the video output circuit.

ON : Normally select this.

Power is supplied to the built-in video output circuit.

OFF : Select to cut off power to the built-in video output circuit while playing an audio source.

With this setting, interference caused by the video output circuit will be reduced.

Note:

Even if “VIDEO POWER” is set to “OFF,” power will be supplied to the video output circuit when on-screen display menus are used.

w Setting the Zone 2/Speakers 2 Usage —ZONE 2/SPEAKER 2

On this submenu, you can determine the output signal type through the ZONE 2 PREOUT jacks, and the usage of the speaker connected to the

FRONT 2/ZONE 2 SPEAKERS terminals.

7ZONE2PREOUT

When connecting the Zone 2 front speakers to the ZONE 2 PREOUT jacks through another amplifier (see page 19), determine how to adjust the volume level in Zone 2.

Select one of the following:

VARIABLE : Select when you want to adjust the Zone 2 volume level using the MASTER VOLUME control on this unit (or VOLUME +/– on this remote control).

FIX	: Select when you want to adjust the Zone 2
	volume level using the amplifier connected to
	the ZONE 2 PREOUT jacks.
	• The MASTER VOLUME control on this unit
	(or VOLUME +/– on this remote control)
	cannot adjust the Zone 2 volume level.

Note:

With “ZONE2PREOUT” set to “VARIABLE,” no sounds come out of the ZONE 2 PREOUT jacks if the volume level is set to “– – – dB.” In this case, increasing the volume level will enable the sound output through the ZONE 2 PREOUT jacks.

43