JVC RX-DP20VBK manual at the same time, Press the play 3 button on the CD player

Automatic Power On/Off (Standby): only possible with the COMPU LINK-3 and COMPU LINK-4 connection

Automatic Power On:

• When you turn on the receiver by pressing (STANDBY/ ON) on the unit, or AUDIO (ON) on the remote control with ZONE 1/ZONE 2 (LEARN/TRANSMIT) selector set to “ZONE 1”:

OR

When you turn on the Zone 1 sound by pressing ZONE 1 ON/ OFF while the receiver is turned on:

\The ZONE 1 ON/OFF lamp lights up, and the source name for Zone 1 appears on the display, and one of the connected components will turn on automatically, depending on which component has been previously selected as the Zone 1 source.

•When you turn on the receiver by pressing

AUDIO (ON) on the remote control, with ZONE 1/ZONE 2 (LEARN/TRANSMIT) selector set to “ZONE 2”:

OR

When you turn on the Zone 2 sound by pressing ZONE 2 ON/OFF while the receiver is turned on:

\The ZONE 2 ON/OFF lamp lights up and one of the connected components will turn on automatically, depending on which component has been previously selected as the Zone 2 source.

Automatic Power Off (Standby):

•When you turn off the receiver by pressing (STANDBY/ ON) on the unit, or AUDIO (STANDBY) on the remote control, the connected components will turn off (standby).

•When you turn off the Zone 1 sound by pressing

ZONE 1 ON/OFF, the selected Zone 1 source component turns off (unless the same component is selected as the Zone 2 source).

–If the ZONE 2 ON/OFF lamp is lit, the Zone 1 source will stop playing, but will not turn off.

•When you turn off the Zone 2 source by pressing

ZONE 2 ON/OFF, the selected Zone 2 source component turns off (unless the same component is selected as the Zone 1 source).

–If the ZONE 1 ON/OFF lamp is lit, the Zone 2 source will stop playing, but will not turn off.

Synchronized Recording

This operation is only possible when the receiver is ready for Zone 1 operations.

Synchronized recording means the cassette deck (or MD recorder) starts recording as soon as a CD begins playing.

To use synchronized recording, follow these steps:

1.Put a tape in the cassette deck (or an MD in the MD recorder), and a disc in the CD player.

2.Press the record (¶) button and the pause (8) button on the cassette deck (or on MD recorder)

at the same time.

This puts the cassette deck (or MD recorder) into recording pause.

If you do not press the record (¶) button and pause (8) button at the same time, the synchronized recording feature will not operate.

3. Press the play (3) button on the CD player.

The Zone 1 source changes on the receiver, and as soon as play starts, the cassette deck (or MD recorder) starts recording. When play ends, the cassette deck (or MD recorder) enters recording pause, and stops about 4 seconds later.

Notes:

•During synchronized recording;

–The selected Zone 1 source cannot be changed. (You can change the Zone 2 source.)

–If the same source is selected both for Zone 1 and Zone 2, operating the Zone 2 source will affect the recording.

•The COMPU LINK remote control system may not operate properly during synchronized recording;

–If the power of any component is shut off.

–If the Zone 1 sound is turned off by pressing ZONE 1 ON/OFF. In this case, you must start recording again from the beginning.

62