JVC RX-DP20VBK Using the Analog Multi-channel Playback Mode, Activating the Analog Multi-channel

Using the Analog Multi-channel Playback Mode

This receiver provides the DVD MULTI and EXT 7.1CH playback modes for reproducing the analog discrete output mode of the DVD player or another component such as a digital decoder. Before using these playback modes, refer also to the manual supplied for those components.

•The following operations are only possible when the receiver is ready for Zone 1 operations, and are used only for the Zone 1 sources—“DVD MULTI” and “EXT 7.1CH.”

Activating the Analog Multi-channel	3. Apply the THX mode or the DSP mode if
	necessary.
Playback Modes
	• Press THX to apply the THX mode.
Perform the basic settings and adjustments using the Setup and	Each time you press the button, “THX U2 CINEMA” or
	“THX MUSIC” will be activated.
Adjustment Menus first (see pages 35 to 50).

Activating DVD MULTI or EXT 7.1CH playback mode automatically recalls the memorized settings and adjustments.

•You also need to set the target component to the analog discrete output mode.

THX

On the unit

THX

From the remote control

IMPORTANT:

Check following before or while using the buttons and controls.

For Zone 1 operations:

The ZONE 1 ON/OFF lamp on the unit is lit.

• When using the unit:

– “ZONE 2” is not shown in the main display.	DOOR
	DOWN

–Press DOOR DOWN to use the buttons inside the front door.

To close the front door, press DOOR UP.

•When using the remote control:

–Set the ZONE 1/ZONE 2 (LEARN/TRANSMIT) selector to “ZONE 1.”

–Check the indication shown on the remote’s display when you press a button on the remote control—this indicates the remote control operation mode together with multi-room operation mode (either ZONE 1 or ZONE 2) for a while.

	LEARN	TRANSMIT
		STANDBY	ON
	ZONE 1	ZONE 2
	ZONE 1	ZONE 2 TV/CATV/DBS	VCR 1
LEARN TRANSMIT	ON/OFF	ON/OFF
		STANDBY/ON	STANDBY/ON

ZONE 1

(inside the front door)

Note:

You cannot apply the THX mode in the following cases:

–When Analog Direct is turned on,

–When the Zone 2 speakers are activated, or

–When the surround back speakers are deactivated or only one surround speaker is used.

•Press DSP to apply one of the DSP modes (except “STEREO FILM” and “MONO FILM”).

Each time you press the button, the DSP modes change in sequence (see page 58 for details).

DSP

DSP

On the unit	From the remote control
(inside the front door)

ZONE 1 ZONE 2

To adjust the speaker output level using the remote control,

see page 56.

Ex. When you press DVD MULTI with

ZONE 1/ZONE 2 (LEARN/TRANSMIT) selector set to “ZONE 1.”

To cancel the THX and DSP modes

Press SURR/DSP OFF.

“DSP OFF” appears on the display.

1. Press DVD MULTI or EXT 7.1 CH.

SURR/DSP	SURR/DSP
	OFF
OFF

DVD MULTI	EXT 7.1CH	EXT 7.1CH
	DVD MULTI		On the unit
				From the remote control
			(inside the front door)

On the unit	From the remote control
(inside the front door)

Note:

To view the pictures through a component connected to the EXT 7.1CH IN jacks, you need to follow one of the methods explained on page 12.

2.Select the analog discrete output mode on the connected component, and start playback.

• Refer to the manual supplied with the connected component.

60