To turn off the sounds temporarily
From the remote control ONLY:
Note:
Before activating the Surround or DSP mode, adjust the speaker
Press MUTING.
MUTING
setting to bring out the best performance from this system.
For
To restore the sound, press MUTING again.
•Pressing AUDIO VOL + or – also restores the sound.
6Activate Surround or DSP Mode
You can enjoy three kinds of
Digital Multichannel
Dolby Digital or DTS Digital Surround takes effect only when you enjoy a disc encoded with its signals.
To activate Dolby Digital or DTS Digital Surround
When a disc encoded with the Dolby Digital or DTS Digital Surround is loaded, the system detects it and starts playing the disc automatically with Multichannel Surround activated.
–For
Dolby Pro Logic
To activate Pro Logic II modes
Press SURROUND. | SURROUND |
The current Pro Logic II mode appears on the display for a while.
•Each time you press the button, Pro Logic II mode changes as follows:
PL II MUSIC 
PL II MOVIE
PL II OFF
• When Dolby Pro Logic II mode is activated, the PRO LOGIC
II indicator lights up on the display.
–For
DSP
THEATER, LIVE HOUSE
To activate DSP modes
Press DSP. | DSP |
The current DSP mode appears on the display for a while.
•Each time you press the button, DSP mode changes as follows:
LIVE HOUSE 
HALL 
CONCERT
DSP OFF 
THEATER 
STADIUM 
–For
7 Stop Playback
Press 7 twice.
Playback stops completely.
•This system can memorize the end point even when you press 7 once. When you start playback again by
pressing 3, playback begins from where it has been stopped— Resume play.
To remove the loaded disc
Press 0.
“OPEN” appears on the display and the disc tray comes out.
To close the disc tray, press 0 again.
To prohibit disc ejection
On the front panel ONLY:
Press and hold 6 and 4 for more than 3 seconds.
“LOCKED” appears on the display, and the disc tray is locked.
To cancel the prohibition, press and hold 6 and 4 for more than 3 seconds. “UNLOCK” appears on the display, and the disc tray is unlocked.
To turn off the power (into standby)
Press AUDIO | (or STANDBY/ON on the front AUDIO |
panel).
The illumination lamp goes off and the STANDBY lamp lights up.
•If you press AUDIO 
(or 
STANDBY/ON on the front panel) while the disc tray is kept open, the disc tray closes automatically, then the system is turned off.
•A small amount of power is consumed even in standby mode. To turn the power off completely, unplug the AC power cord.
13
