JVC UXQD90S 1, 2

Introduction

17

(Continued)

Basic Operations

Press four times to display the clock, and

then adjust the clock starting from step 2 on page

16.

Press repeatedly.

NOTE

• The time display on the main unit is a 24-hour

clock.

• The clock will gain or lose approximately 1 minute

per month.

• Set the clock again after you have disconnected

the power plug or a power is interrupted.

Press (or on the main unit).

• With the power off, pressing either button

also turns on the main unit.

Remote control:

Main unit:

When a disc or cassette tape has been

loaded, playback starts automatically.

NOTE

• Cooling fan is built into the main unit for emitting

generated heat. When you turn on the main unit,

the internal cooling fan automatically starts rotating.

Press .

NOTE

• You can also adjust the volume by turning the

VOLUME control on the main unit.

• You can adjust the volume within the range of 0

to 40.

Press .

• Each time you press , the display

changes as follows.

• While the sound mode is set to an item other

than "FLAT", is displayed in the

display window.

NOTE

• This function does not affect recording sound.

1Press repeatedly to display

"MANUAL".

2For adjusting bass sound;

Press .

For adjusting treble sound;

Press .

• You can adjust the sound quality within the

range of -5 to +5.

• The display returns to the sound source dis-

play in a few seconds.

NOTE

• While the sound mode is set to an item other than

"MANUAL", "NO OPERATE" is displayed in the dis-

play window and you cannot adjust bass/treble

sound.

Turning On/Off the Main Unit

Adjusting the Volume

Adjusting the clock

Displaying the clock while using the

main unit

Adjusting the Sound Quality

Selecting the sound mode

: For emphasizing treble

and bass sounds.

: Adequate for songs

and narrations.

: For emphasizing treble

sound.

: For uplifting a feeling

of being at a live per-

formance.

: For adjusting treble and

bass sounds of your

choice (shown below).

: Cancels the sound

mode (factory setting).

Adjusting bass/treble sound

UX-QD90[UNUS].book Page 17 Thursday, September 29, 2005 1:29 PM

Contents

Main MICRO COMPONENT DVD SYSTEM DVD UX-QD90S Consists of CA-UXQD90S and SP-UXQD90S CA-UXQD90S SP-UXQD90S INSTRUCTIONS English Warnings, Cautions and Others / G-1 IMPORTANT FOR LASER PRODUCTS / CAUTION G-2 Front view Side view 1 Table of Contents Listening to Discs Basic Operations Notes on Operation.............................. 3 Special Cautions................................... 6 2 Reference Listening to Cassette Tapes Listening to Other Equipment Recording Sound Convenient Functions Notes on Operation Suitable Locations for the Main Unit Listener's Etiquette Condensation Cleaning the Main Unit Playable DVD/CD Types Notes on Operation Disc Structure Introduction English Special Cautions Important cautions Supplied Accessories Safety precautions When condensation or water drops adhere to the lens Voltage Adjustment Introduction/Preparation English Part Description 9 Remote Control Remote control operation Inserting Batteries into the 10 1 Press number buttons ( - , ). selector to the TV side. 2 Hold down until step 4 is completed. Connections 1 2 3 When radio reception with the supplied AM loop antenna is poor Connect all necessary parts before connecting the power plug. 12 Preparation English When radio reception with the supplied FM antenna is poor, or when using a communal antenna Connecting the FM antenna Connect all necessary parts before connecting the power plug. Connecting the Speakers 14 Connecting Other Equipment Read this section when connecting other audio equipment to this product. Other audio equipment Audio cord (not supplied) Connecting with digital equipment Connecting with a TV Hold down on the main until "DEMO CLEAR" appears. When a Clearer Picture Is Desired Connecting by using the S-video cord Connecting by using the component video cord Connecting the Power Plug Basic Operations 1 2 or 3 4 5 6 1 "MANUAL". 2 Press . For adjusting treble sound; Press . Turning On/Off the Main Unit Temp orar ily Tu rnin g Off the Sound (FADE MUTING) Emphasizing Heavy Bass Sound (AHB PRO) Changing the Display Brightness (DIMMER) Changing the Color Patterns Basic operations 1 2 3 2 seconds. Currently selected color system and the video processing system appear on the dis- play window. Listening to Radio Broadcasts Setting the AM Tuner Spacing 1 2 Tuning In to a Preset Radio Station 1 3 4 1 2 Selecting a Radio Station Storing Radio Stations (Preset) Listening to Radio Broadcasts/Listening to Discs English Basic Operations of the DVD Player Display while the DVD VIDEO is stopped: (Refer to page 37 for playing back MP3/WMA and JPEG.) 1 The disc tray comes out. Display for a DVD VR Display for CD Display for DVD AUDIO Display for VCD/SVCD Listening to Discs English Playing Back from a Position 10 Seconds Before (One Touch Replay) PBC (Playback control) 25 How to suspend playback 2510 20 60 Stopping Playback Resuming Playback (RESUME) Pausing Playback Advancing Picture Frame by Frame Fast Reverse/Fast Forward Search 1 selector to AUDIO. 2 or ) to select the track/ chapter you want to listen to. Slow Motion Playback 1 2 3 4 1 2 3 Selecting a Track from the Menu Screen Using the Menu Screen for DVD VRs Convenient Functions of the DVD Player While a disc containing two or more audio is being played back 2/3 CHINESE Example: For DVD VIDEO Each time you press , the audio will be changed. The audio can changed by pressing . 2 subtitle. Magnifying the Picture (ZOOM) While a disc containing two or more view angles is being played back Select the portion you want to see by pressing 2 5 to select VFP mode. 1 2 playback to select a bonus group. 3 the pin code (4 digits). 1 Press to select "PROGRAM". 3 or ) to program chapters/ tracks. Browsable Still Pictures (B.S.P.) 33 Display for CD/VCD/SVCD Erasing the whole program Display for MP3/WMA While playback is stopped, press or repeatedly. 1 "RANDOM". Example: For CD "RANDOM" appears in the TV screen. While playback is stopped, press repeatedly to display an item other than "RANDOM". Status Bar and Menu Bar Function list Number buttons VCD/SVCD/CD (the example below is for a CD) You can display the status bar and menu bar on the TV screen, and can control discs with the bars. 2 Canceling A-B repeat playback 4 5 6 2 3 5 Playing Back the Designated Part Repeatedly (A-B Repeat Playback) Designate the Time (Time Search) Playing Back MP3/WMA and JPEG Discs 1 2 3 4 Slide-show playback Preferences Basic Operations This section explains basic operation for changing various settings. While a disc is stopped or no disc is loaded (while "NO DISC" is displayed) Proceed with operations by following the description on the TV screen. AUDIO List of relationships of DIGITAL AUDIO OUTPUT preference items and output signal OTHERS Language Codes Listening to Discs/Listening to Cassette Tapes English Listening to Cassette Tapes 1 2 the reverse mode. Listening to Other Equipment 1 2 3 Adjusting the Sound Input Level from Other Equipment 44 Recording Sound to Cassette Tapes 1 ing. 2 mode. 3 4 Quitting Recording Recording Only One Track from a Disc Recording the Second or Subsequent Track to the Last Track from a Disc 46 Using the Timers Sleep Timer Changing the sleep timer setting Confirming the sleep timer setting (remaining time) 1 2 3 5 6 8 13 14 1 want to play back. 2 7 desired day of the week. 8 9 "PLAY TIMER". 10 11 Auto Standby When the disc or cassette tape is selected as a sound source Press once again. Auto standby performance 51 Disc Ejection Lock Canceling the disc ejection lock Operations While holding down , press on the main unit. Using AV COMPU LINK Handling Discs/Cassette Tapes Cleaning the main unit cabinet Handling discs Cleaning discs Handling cassette tapes Cleaning the tape deck head Disc Messages Troubleshooting 54 Reference English Specifications DVD receiver (CA-UXQD90S) Speaker (SP-UXQD90S) Micro component DVD system (UX-QD90S) UX-QD90SMICROCOMPONENTDVDSYSTEM Mains (AC) Line Instruction (AC) Bottom view of the main unit MICRO COMPONENT DVD SYSTEM English UX-QD90S Consists of CA-UXQD90S and SP-UXQD90S INSTRUCTIONS Warnings, Cautions and Others G-1 IMPORTANT FOR LASER PRODUCTS CAUTION CAUTION F button! G-2 CAUTION Proper Ventilation In addition, maintain the best possible air circulation. 1 Table of Contents Listening to Discs Basic Operations Basic Operations of the DVD Player Notes on Operation .............................. 3 2 Reference Listening to Cassette Tapes Listening to Other Equipment Recording Sound Convenient Functions Notes on Operation Suitable Locations for the Main Unit Listener's Etiquette Condensation Cleaning the Main Unit Playable DVD/CD Types Notes on Operation Disc Structure Special Cautions Important cautions Supplied Accessories Safety precautions When condensation or water drops adhere to the lens Voltage Adjustment Introduction/Preparation Part Description 9 Remote Control Remote control operation Inserting Batteries into the 10 1 Press number buttons ( - , ). selector to the TV side. 2 Hold down until step 4 is completed. Connections 1 2 3 When radio reception with the supplied AM loop antenna is poor Connect all necessary parts before connecting the power plug. 12 When radio reception with the supplied FM antenna is poor, or when using a communal antenna Connecting the FM antenna Connect all necessary parts before connecting the power plug. Connecting the Speakers 14 Connecting Other Equipment Read this section when connecting other audio equipment to this product. Other audio equipment Audio cord (not supplied) Connecting with digital equipment Connecting with a TV Hold down on the main until "DEMO CLEAR" appears. When a Clearer Picture Is Desired Connecting by using the S-video cord Connecting by using the component video cord Connecting the Power Plug Basic Operations 1 2 or 3 4 5 6 1 "MANUAL". 2 Press . For adjusting treble sound; Press . Turning On/Off the Main Unit Temporarily Turning Off the Sound (FADE MUTING) Emphasizing Heavy Bass Sound (AHB PRO) Changing the Display Brightness (DIMMER) Changing the Color Patterns Basic operations 1 2 3 2 seconds. Currently selected color system and the video processing system appear on the dis- play window. Listening to Radio Broadcasts Setting the AM Tuner Spacing 1 2 Tuning In to a Preset Radio Station 1 3 4 1 2 Selecting a Radio Station Storing Radio Stations (Preset) Listening to Radio Broadcasts/Listening to Discs Basic Operations of the DVD Player Display while the DVD VIDEO is stopped: (Refer to page 37 for playing back MP3/WMA and JPEG.) 1 The disc tray comes out. Basic Operations of the DVD Player Display for a DVD VR Display for CD Display for DVD AUDIO Display for VCD/SVCD Playing Back from a Position 10 Seconds Before (One Touch Replay) PBC (Playback control) 25 How to suspend playback 2510 20 60 Stopping Playback Resuming Playback (RESUME) Pausing Playback Advancing Picture Frame by Frame Fast Reverse/Fast Forward Search 1 selector to AUDIO. 2 or ) to select the track/ chapter you want to listen to. Slow Motion Playback 1 2 3 4 1 2 3 Selecting a Track from the Menu Screen Using the Menu Screen for DVD VRs Convenient Functions of the DVD Player While a disc containing two or more audio is being played back 2/3 CHINESE Example: For DVD VIDEO Each time you press , the audio will be changed. The audio can changed by pressing . 2 subtitle. Magnifying the Picture (ZOOM) While a disc containing two or more view angles is being played back Select the portion you want to see by pressing 2 5 to select VFP mode. 1 2 playback to select a bonus group. 3 the pin code (4 digits). 1 Press to select "PROGRAM". 3 or ) to program chapters/ tracks. Browsable Still Pictures (B.S.P.) Confirming programmed content Canceling program playback Erasing the whole program 34 1 "RANDOM". Example: For CD "RANDOM" appears in the TV screen. While playback is stopped, press repeatedly to display an item other than "RANDOM". Status Bar and Menu Bar Function list Number buttons VCD/SVCD/CD (the example below is for a CD) You can display the status bar and menu bar on the TV screen, and can control discs with the bars. 2 Canceling A-B repeat playback 4 5 6 2 3 5 Playing Back the Designated Part Repeatedly (A-B Repeat Playback) Designate the Time (Time Search) Playing Back MP3/WMA and JPEG Discs 1 Playback 2 3 4 Slide-show playback Preferences Basic Operations This section explains basic operation for changing various settings. While a disc is stopped or no disc is loaded (while "NO DISC" is displayed) Proceed with operations by following the description on the TV screen. AUDIO List of relationships of DIGITAL AUDIO OUTPUT preference items and output signal OTHERS Language Codes Listening to Discs/Listening to Cassette Tapes Listening to Cassette Tapes 1 2 the reverse mode. Listening to Other Equipment 1 2 3 Adjusting the Sound Input Level from Other Equipment 44 Recording Sound to Cassette Tapes 1 ing. 2 mode. 3 4 Quitting Recording Recording Only One Track from a Disc Recording the Second or Subsequent Track to the Last Track from a Disc 46 Using the Timers Sleep Timer Changing the sleep timer setting Confirming the sleep timer setting (remaining time) 1 2 3 5 6 8 13 14 1 want to play back. 2 7 desired day of the week. 8 9 "PLAY TIMER". 10 11 Auto Standby When the disc or cassette tape is selected as a sound source Press once again. Auto standby performance 51 Disc Ejection Lock Canceling the disc ejection lock Operations While holding down , press on the main unit. Using AV COMPU LINK Handling Discs/Cassette Tapes Cleaning the main unit cabinet Handling discs Cleaning discs Handling cassette tapes Cleaning the tape deck head Disc Messages Troubleshooting 54 Reference Specifications DVD receiver (CA-UXQD90S) Speaker (SP-UXQD90S) Micro component DVD system (UX-QD90S) Mains (AC) Line Instruction