Connecting to the DC12 V power supplyConnect this product to the DC12 V power supply when not using the PoE.Connect the polarity correctly.Red : DC12V+Black : DC12V-

Note :

●Make sure to select only one mode of electrical supply. Connecting the power cable and the LAN cable for the PoE at the same time may result in failure or malfunction of the camera.

Power cable

Black: DC12 V-

Red: DC12 V+

Solder or

Solder or

crimp

crimp

Wind the

Insulation tape

Insulation tape

waterproof

 

 

tape.

 

 

Warning

The rated power of this product is DC12 V. Make sure to use it with the correct voltage. Supplying a power different from the rated value may result in failures and in the worst scenario, smoking and fire.

Memo :

●In a system where multiple units of VN- C215V4U are used, turn on the power of only 1 unit to configure the IP address settings via the Internet Explorer. Upon doing so, turn on the power of the second unit and configure accordingly. Configure the camera settings using the same procedure.

●Whenever duplication of IP addresses occurs, check that there is only one VN- C215V4U under the same LAN environment and wait for at least 10 minutes. Access to VN-C215V4Umay be denied unless you restore the power supply of all network devices under the same LAN environment.

●To use AA-P700in the power supply unit, connect one unit of this product. Also refer to the AA-P700instruction manual.

ENGLISH

Memo :

About the power cable

●When using 2-core VVF (Vinyl-insulated vinyl-sheath cable), the connection distance is as follows: (Reference value)

Maximum

40

120

190

extension (m)

 

 

 

 

 

 

 

Conductor

R1.0 and

R1.6 and

R2.0 and

Diameter (mm)

above

above

above

 

 

 

 

 

 

 

 

E-25