Basic operations

Basic operations

STANDBY/ON indicator

NOTE

Make sure that the TV - DVD switch on the

TV DVD remote control unit is set to “DVD” when using the 5//2/3 and numeric buttons

for controlling the player.

About invalid operation icon

When you press a button, and if the player does not accept its operation, appears on your TV screen. Operations are occasionally unacceptable even if is not displayed.

Note that some operations may not be accepted. For example, some discs may not allow rapid advance/reverse or slow- motion playback.

CANNOT READ THIS DISC (The player cannot play back the disc.)

OPEN (The disc tray is opening.)

CLOSE (The disc tray is closing.)

NO DISC (No disc is loaded.)

NOTES

Even if you turn off the player, the player is not disconnected from the AC power source as long as it is connected to the wall outlet. This state is called standby mode. In this state, the player consumes a very small amount of power.

You can change the picture of the opening display. (See page 26.)

Initial setup

When you turn on the player for the first time, the following message appears on the TV screen.

EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO SETTING

YES - PRESS ENTER NO - PRESS CANCEL

1 Press ENTER.

The first page of the DVD PLAYER SET UP display appears. The pull-down menu of the [ON SCREEN LANGUAGE] is already open.

ON SCREEN LANGUAGE options

2 Press 5/to select the desired language.

You can select the on-screen language for the preference displays, etc. from among ENGLISH, FRENCH, and

SPANISH.

Turning on/off the player

Press DVD STANDBY/ON on the remote control unit or press on the front panel.

The STANDBY/ON indicator on the front panel, which lights in red during standby, lights in green.

The left and right sides of the display window are illuminated.

The opening display appears on the TV screen, and the following messages may appear at the bottom of the opening display.

NOW READING

NOW READING

Message area

NOW READING (The player is reading the disc information.)

REGION CODE ERROR! (The region code of the DVD VIDEO disc does not match the player. The disc cannot be played back.)

3 Press ENTER.

The second page is shown, in which the pull-down menu of the [MONITOR TYPE] is already open.

MONITOR TYPE options

4 Press 5/to select the desired monitor type.

For a normal (conventional) TV, select [4:3 LB] or [4:3 PS]. For a wide-screen TV, select [16:9]. (See page 29.)

10

Page 14
Image 14
JVC XV-NP10S manual Basic operations, Initial setup, Turning on/off the player