Kenmore 110.4492, 110.4493, 110.4292 manual Installation Instructions, Grounding mNSTRUCTmONS

•Do not ground to a gas pipe.

•Check with a qualified electrician if you are not sure the washer is properly grounded.

•Do not have a fuse in the neutral or ground circuit.

1 2

................3

1.3prong grounding plug

2.3 prong grounding-type wall receptacle

3.Grounding prong

4.Power supply cord

INSTALLATION

INSTRUCTIONS

Excessive Weight Hazard

Use two or more people to move and install washer.

Failure to do so can result in back or other injury.

IMPORTANT: Position the washer so that the rear of the unit is within approximately 3 ft (90 cm) of the final location.

There are 4 bolts in the rear panel of the washer that support the suspension system during transportation. These bolts also retain the power cord inside the washer until the bolts are removed.

GROUNDING mNSTRUCTmONS

For a grounded, cord-connected washer:

This washer must be grounded. Hnthe event of a maHfunction or breakdown, grounding wHHreduce the risk of eHectricaH shock by providing a path of Heast resistance for eHectric current. This washer is

equipped with a cord having an equipment-grounding conductor and a grounding pHug. The pHug must be

pHugged into an appropriate			outHet that is properHy
instaHHed and grounded		in accordance			with aHHHocaH
codes and	ordinances.
WARNING:	Hmproper		connection		of the
equipment-grounding		conductor		can resuHt in a risk of
eHectric shock. Check with a quaHified eHectrician or
serviceman	if you are	in doubt		as to	whether the
appHiance	is properHy	grounded.

Do not modify the pHug provided with the appHiance - if it wiHHnot fit the outHet, have a proper outHet instaHHed by a quaHified eHectrician.

For a permanentJy connected washer:

This washer must be connected to a grounded metaH, permanent wiring system, or an equipment grounding conductor must be run with the circuit conductors and

connected to the equipment-grounding terminaH or Head on the appHiance.

1.Using a 13 mm wrench, loosen each of the bolts.

2.Once the bolt is loose, move it to the center of the hole and

completely pull out the bolt, including the plastic spacer covering the bolt. The power cord will be attached to all 4 bolts inside the washer.

3.Once all 4 bolts are removed, pull the power cord through the opening of the rear panel and close the hole with the attached cap.

4.Close the bolt holes with the 4 transport bolt hole plugs.

NOTE: If the washer is to be transported at a later date, call your local service center. To prevent suspension and structural damage, your machine must be properly set up for relocation by a certified technician.