@NT.
Ice maker arm is not in correct position.
AND
Ice maker is not
_roducing ice
Waterfilter indicator light
is red
Refrigerator is leaking
water
Iceforms in inlet tube
to ice maker
Waterflowisslower
thannormal
Dispenserwater isnot
cold
Householdwater supply is not reaching
water valve
Copper or plastic tubing has kinks.
Water pressure is too low.
Checkfreezer temperature.
Ice bin is not installed properly
Improperwater valve was installed.
Waterfilter needsto be replaced.
Filter indicator sensor needs to be reset.
Plastictubing was used to completewater
connection.
Improperwater valve was installed
Water pressure is low.
Freezertemperature is too high.
Waterpressure is too low.
Improperwater valve was installed.
Copper or plastic tubing has kinks.
Water filter is clogged or needs to be
changed.
Refrigeratorhas been recently installed.
Water supply in holding tank has been
depleted.
Waterhas settled into water lines outside
holding tank and has warmed to room
temperature.
Confirm ice maker arm is down. See Freezer Features
section in your owner's manual for details
Checkwater connection procedurewritten in Installing Your
Refrigerator.
Turn off water supply and remove kinks. If kinks cannot be
removed,replace tubing.
Waterpressure must be between20 to 100 pounds per square
inchto function properly.A minimumpressure of 35 pounds per
squareinch is recommendedfor refrigeratorswith water filters.
Seetemperature controlssection in Installing Your
Refrigerator to adjust your controls.Freezer must be
between 0to 2°F (-18 to -17 ° C) to produce ice.
See ice bin section for proper installation and alignment.
Check water connection procedurein your Installation
Instructions. Self-piercing and %" saddle valves cause low
water pressure and may clog theline over time. The
manufacturer is not responsible for property damage due
to improper installation or water connection.
Iffilter is not available, replace with bypassfilter. See
Dispenser Features section for directions.
See Dispenser Features sectionfor directions.
The manufacturer recommends using copper tubing for
installation. Plasticis less durable and cancause leakage.
The manufacturer is not responsible for property damage
dueto improperinstallation or water connection.
Check waterconnectionprocedurein your Installation
Instructions. Self-piercingand %" saddle valves cause low
water pressure and may clogthe line over time. The
manufacturer is not responsible for property damage due
to improper installation or water connection.
Water pressure must be between 20 to 100 pounds per
squareinch to function properly. A minimum pressureof 35
poundsper square inch is recommended for refrigerators with
waterfilters.
Seetemperature controlssection in Installing Your
Refrigerator to adjustyour controls. Freezer must be
between0 to 2 ° F (-18 to -17 °C) to produce ice.
Water pressure must be between 20 to 100 pounds per
square inch to function properly.A minimum pressure of 35
pounds per square inch is recommendedfor refrigerators with
water filters.
Check water connection procedure in your Installation
Instructions. Self-piercing and _,6"saddlevalves cause low
water pressure and may clogthe line over time. The
manufacturer is not responsible for property damage due
to improper installation orwater connection.
Turnoff water supply and remove kinks. If kinks cannot be
removed,replace tubing.
Changewater filter.
Allowapproximately 12hours for water in holding tank to chill.
Discardfirst glass of water and refill.
Z8