Kenwood DNX6040EX Rear, NOTE, Front, Front, Phase, Slope, HPF FREQ, LPF FREQ, Subwoofer, Touch [X’over], Crossover network setup, Set each item as follows

Return to the Top page

Audio Setting Up

3 Select a speaker size using [2] and [3]. The speaker size is different depending on the speaker type and the unit.

Front

OEM, 4 inch, 5 inch, 6-1/2 inch, 6-3/4 inch, 7 inch, 4x6, 5x7, 6x8, 6x9, 7x10

Rear

None, OEM, 4 inch, 5 inch, 6-1/2 inch, 6-3/4 inch, 7 inch, 4x6, 5x7, 6x8, 6x9, 7x10

Subwoofer

None, 6 1/2 inch, 8 inch, 10 inch, 12 inch, 15 inch over

NOTE

• Select “None” if you have no speakers.

Front

Standard, Wide, Middle, Narrow

Crossover network setupYou can set a crossover frequency of speakers.

1	Touch the speaker to set the crossover
	in the Speaker Select screen.
2	Touch [X’over].
	X’over screen appears.
3	Set each item as follows.

Phase*

Sets the phase of subwoofer output.

The phase is reversed 180 degrees when set to “Reverse.”

HPF FREQ

High Pass Filter adjustment. (When front or rear speaker is selected on Speaker Select screen)

LPF FREQ

Low Pass Filter adjustment. (When subwoofer is selected on Speaker Select screen)

Slope

Sets a crossover slope.

* This function is available in the specific situation.Only when “Subwoofer” is set to “ON” in “Speaker Setup”. Only when “Subwoofer” is

set to “ON” in “Speaker Setup” and “LPF FREQ” is set to other than “Through”.

82