Kenwood DNX6040EX Error Messages, Other, Cause, Reason, (P.97), Problem, Solution, Solution, Troubleshooting, Parental level (P.26), Return to the Top page

			Return to the Top page
			Troubleshooting
	Other
	Problem	Reason	Solution
The Touch Sensor Tone doesn’t		The preout jack is being	The Touch Sensor Tone cannot be output
sound.		used.	from the preout jack.

Error Messages

When you fail to operate the unit correctly, the cause of the failure appears as the message on the screen.

Error Message	Cause	Solution
Protect	Protective circuit has been activated	Wire or insulate the speaker cord as
	because a speaker cord has shorted	appropriate and then push the <Reset>
	or it has come in contact with the	button (P.97).
	car chassis.
Hot Error	When the internal temperature of	Use the unit again after reducing the
	this unit rises to 60°C or more, the	temperature of the unit.
	protection circuit is activated and
	you may not be able to operate
	the unit.
Mecha Error	The disc player is malfunctioning.	Eject the disc and try inserting it again. Contact
		the Kenwood dealer if this indicator continues
		blinking or the disc cannot be ejected.
Disc Error	An unplayable disc is inserted.	Change the disc.
		See Playable Media And Files (P.98).
Read Error	The disc is quite dirty.	Clean the disc.
		See Precautions on handling discs (P.4).
	Disc is upside down.	Load the disc with the labeled side up.
Region Code	The disc you wanted to play has a	See Region Codes In The World (P.103) or try
Error	region code that cannot be played	another disc.
	with this unit.
Parental Level	The disc you wanted to play has a	Set the parental level.
Error	higher level than the parental level	See Parental level (P.26).
	you set.
Error 07–67	The unit is not operating correctly	Push the unit’s Reset button. If the “Error
	due to some reason or other.	07−67” message does not disappear, see your
		nearest Kenwood dealer.
No Device (USB	The USB device is selected as a	Change the source to any source other than
device)	source although no USB device is	USB/iPod. Connect a USB device, and change
	connected.	the source to USB again.
Disconnected	The iPod/Bluetooth audio player	Change the source to any source other than
(iPod, Bluetooth	is selected as a source although	iPod/Bluetooth. Connect an iPod/Bluetooth
audio player)	no iPod/Bluetooth audio player is	audio player, and change the source to iPod/
	connected.	Bluetooth again.
No Media file	The connected USB device contains	See Playable Media And Files (P.98) and try
	no playable audio file. Media was	another USB device.
	played that doesn’t have data
	recorded that the unit can play.

95